Abstract:Objectives: The depth of cure using blue-light photocuring units (BL) is limited by tooth structure and qualities of the restorative material through which the activating wavelength must pass. Recent developments incorporate an infrared (IR) activated upconversion (UC) fluorescence of a lining agent filled with nanocrystals of NaYF4 and doped with YB+3 and Tm+3 that emit both blue and violet light locally at the interface of the liner and restorative resin. The purpose of this study was to evaluate the BL and 975 nm infrared (IR) light power transmission through dental tissues and restorative materials. Methods and materials: Power transmissions of the IR laser (975 nm) and a monowave blue-only light-curing unit (Bluephase 16i) through dental tissues (enamel, dentin, and enamel/dentin junction, or DEJ), eight (8) various dental resin composites, and eight (8) dental ceramics, each at four thicknesses (1, 2, 3 and 4 mm) were evaluated (n=5) using a thermopile sensor (PM10, Coherent Inc) connected to a laser power meter (Fieldmate, Coherent Inc). Power transmission values of each light source and restorative material were subjected to analysis of variance and Tukey test at a pre-set alpha of 0.05. Results: A linear correlation (r=0.9884) between the supplied current and emitted IR power of the laser diode was found, showing no statistical power reduction with increased distances (collimated beam). For tooth tissues, the highest power transmissions for both light sources were observed using 1.0 mm enamel while the lowest values were found for 2.0 mm dentin and an association of 2.0 mm DEJ and 1.0 mm dentin. The only group where IR demonstrated significantly higher transmission when compared to BL was 1.0 mm enamel. For all resin composites and dental ceramics, increased thickness resulted in a reduction of IR power transmission (except for EverX Posterior fiber-reinforced composite and e.max HT ceramic). IR resulted in higher transmission through all resin composites, except for Tetric EvoCeram White. The highest BL transmission was observed for SDR Flow, at all thicknesses. Higher IR/BL ratios were observed for EverX Posterior, Herculite Ultra, and Lava Ultimate, while the lowest ratio was observed for Tetric EvoCeram White. Reduced translucency shades within the same material resulted in lower power ratio values, especially for BL transmission. Higher IR/BL ratios were observed for e.Max LT, VitaVM7 Base Dentin, and e.max CAD HT, while the lowest values were found for VitaVM7 Enamel and Paradigm C. Conclusion: IR power transmission through enamel was higher when compared to blue light, while no difference was observed for dentin. The power transmission of IR was higher than BL for resin composites, except for a high value and low chroma shade. Fiber-reinforced resin composite demonstrated the highest IR/BL power transmission ratio. A greater IR/BL ratio was observed for lower translucency ceramics when compared to high translucency.

Does the Transillumination Technique Using a Diagnostic White Tip Influence the Degree of Conversion of the Infiltrant Resin? A Case Report With In Vitro Insights

Optimizing Resin Infiltration Procedure in Molar Incisor Hypomineralization Lesions

Management of white spot enamel lesions with resin infiltration: potentials and future research directions

Effect of preheating and curing lamp distance on the degree of conversion of four nanohybrid resins: An in vitro study

A Fluorescence-based Method to Reaccess Root Canals in Endodontically Treated Teeth: A Micro-Computed Tomography Tridimensional Assessment

Effect of Rapid High-Intensity Light-Curing on Increasing Transdentinal Temperature and Cell Viability: An In Vitro Study

Comparative evaluation of esthetic changes in nonpitted fluorosis stains when treated with resin infiltration, in-office bleaching, and combination therapies

Effect of short LED lamp exposure on wear resistance, residual monomer and degree of conversion for Filtek Z250 and Tetric EvoCeram composites

Influence of the composition and shades of ceramics on light transmission and degree of conversion of dual-cured resin cements

Evaluation of fluorescence of dental composites using contrast ratios to adjacent tooth structure: a pilot study

Evaluating the effect of preheating on resin composites in pit-and-fissure caries treatments with a digital intraoral scanner

Photomicrographic evaluation of the apical sealing capacity of three types of gutta-percha master cones: an in vitro study

Effect of resin composite shade on digital fiber-optic transillumination imaging in vitro

Effect of the type of application tip for 35% hydrogen peroxide on bleaching efficacy and tooth sensitivity: A randomized clinical trial

Degree of conversion and contraction stress development of a resin composite irradiated using halogen and LED at two C-factor levels

Influence of different application protocols of universal adhesive system on the clinical behavior of Class I and II restorations of composite resin – a randomized and double-blind controlled clinical trial

Effect of a brush tip on in-office bleaching gels in an attachable syringe: Hydrogen peroxide penetration, bleaching efficacy and amount of gel expended

Comparison of Blue and Infrared Light Transmission Through Dental Tissues and Restorative Materials

Assessment of Enamel Color Stability of Resins Infiltration Treatment in Human Teeth: A Systematic Review

Micro-Raman spectroscopic analysis of the degree of conversion of composite resins containing different initiators cured by polywave or monowave LED units

Experimental Evaluation of a Novel Device to Quantify Canal Cleanliness: An In Vitro Study