Abstract:Research and industrial application can require custom high-level controllers for industrial drones. Thus, this paper presents the high-fidelity dynamic and control model identification of the DJI M600 Pro hexacopter. This is a widely used multicopter in the research and industrial community due to its high payload capability and reliability. To support these communities, the focus of control model identification was on the exploration and implementation of DJI Onboard Software Development Kit (OSDK) functionalities, also including some unconventional special modes. Thus, the resulting model can be controlled with the same OSDK functionalities as the real drone, making control development and application time effective. First, the hardware and software structure of the additional DJI M600 onboard system are introduced. Then, the postulated dynamic and control system models are shown. Next, real flight test campaigns generating data for system identification are presented. Then, the mass and inertial properties are estimated for TB47S and TB48S battery sets and the custom Forerunner UAV payload. Dynamic system model identification includes the aerodynamic effects and considers hover, vertical, and horizontal forces together with static horizontal wind components and finally the rotational moments and dynamics. The control system components were identified following the structure of OSDK, including vertical, horizontal, and yaw loops. After identification, the model was validated and refined based on an unused flight test and software-in-the-loop simulation data. The simulation is provided by DJI and was also compared to real flight results. This comparison showed that the DJI simulation covers the dynamics of the real drone well, but it requires being connected to the drone and needs the controllers onboard to be implemented in advance, which limits applicability and increases development time. This was another motivation to introduce a standalone simulation in Matlab Simulink, which covers all the important modes of OSDK control and can be run solely in Matlab without any hardware support. The constructed model will be published for the benefit of the research and industrial community.

Parameter identification for pilot behaviour model using the MATLAB system identification toolbox

Grey-box modeling of a small-scale helicopter using physical knowledge and Bayesian Techniques

Pilot Model Parameters Identification Based Least Square Method

Some notes on MPC relevant identification

Pipeline parameter identification of non-stationary flows based on LabVIEW

A Modeling Method of Miniature Unmanned Helicopter Based on Parameter Identification

On extended state Kalman filter-based identification algorithm for aerodynamic parameters

System Identification and Simulation Toolbox under MATLAB Environment

Parameter identification algorithm for a LTV system with partially unknown state matrix

Neural Network Based System Identification and Control Toolboxes in Matlab Environment

Dynamic Model Identification of a Small Satellite Simulator

Aerodynamic Parameter Identification of UAV Based on Output-Error Method

Flight-Data-Based High-Fidelity System Identification of DJI M600 Pro Hexacopter

Adaptive Identification Control Method for Aircraft Dynamic Parameters under Passive Excitation

A Weighted Least-Squares Method for Non-Asymptotic Identification of Markov Parameters from Multiple Trajectories

Deep Learning of Dynamic Systems using System Identification Toolbox(TM)

SIMBa: System Identification Methods leveraging Backpropagation

Time-domain maximum likelihood model and its application in the identification of aircraft flying quality parameters

Recognition of Different Turning Behaviors of Pilots Based on Flight Simulator and fNIRS Data

Recursive Method in Modal Parameter Identification of Aerospace Structures under Non-Gaussian Noise

Design of Input Signal for System Identification of a Generic Fighter Configuration