Abstract:Bitumen fatigue resistance is critical to determine the overall fatigue performance and service life of asphalt pavements. However, the mechanisms responsible for fatigue damage of bitumen have previously not been well understood. Molecular dynamics (MD) simulation has recently emerged as a powerful computer-aided numerical technique to model the microscopic failure behaviours in materials. This study aims to use the MD method to investigate the molecular origin of bitumen fatigue damage. The molecular models of the virgin and aged PEN70/100 bitumen were firstly constructed based on their saturate, aromatic, resin and asphaltene (SARA) four fractions. An MD equilibrium was run on the developed bitumen models with the assigned interatomic potentials. Following an MD-based tensile simulation, a strain-controlled fatigue simulation was performed to study the nanostructure and damage behaviours of the virgin and aged bitumen under fatigue loading by calculating the stress-strain response, potential energy, molecular structure and nanovoid volumes. Furthermore, a rheometer measurement was also conducted to characterise the fatigue damage of the bitumen directly by a crack length at the macroscale. Results indicate that the bitumen molecules become unfolded and tend to align along the loading direction when fatigue loading was applied. The change in the molecular configuration helped the molecular chains move closer together and thus contributed to the reduction of the intermolecular interactions including the van der Waals and Coulombic energies. With the increasing load cycles, nanovoids were formed and grew in the bitumen through molecular rearrangement and movement, leading to microscopic fatigue damage of the bitumen. It was found that the aged bitumen produced more severe fatigue damage than the virgin bitumen, which was indicated by the MD-based nanovoid volume at the molecular scale and the DSR-based crack length at the macroscale. The findings from MD simulation provide a fundamental understanding of the molecular origin of fatigue damage, that cannot be experimentally detected for bitumen materials.

Atomic-Level Insights into the Mechanisms of Reinforcement and Fracture in a Graphene-Reinforced Bitumen Composite

Multiscale Modelling of Bitumen-Aggregate Interfaces from Molecular Debonding to Pull-off Strength

A New Sequential Multiscale Model for Interface Failure of Graphene Reinforced Epoxy Nanocomposites Based on MD and SBFEM

A Lennard-Jones Potential Based Cohesive Zone Model and Its Application in Multiscale Damage Simulation of Graphene Reinforced Nanocomposites

Exploiting the synergetic effects of graphene and carbon nanotubes on the mechanical properties of bitumen composites

Modeling Percentages of Cohesive and Adhesive Debonding in Bitumen-Aggregate Interfaces Using Molecular Dynamics Approaches

Enhancement of Rheological Performance and Compatibility of Tire Rubber-Modified Asphalt Binder with the Addition of Graphene

An atomistic study on the thermomechanical properties of graphene and functionalized graphene sheets modified asphalt

A multiscale modeling on fracture and strength of graphene platelets reinforced epoxy

Composite Structural Modeling and Tensile Mechanical Behavior of Graphene Reinforced Metal Matrix Composites

Multiscale Investigations into the Fracture Toughness of SiC/graphene Composites: Atomistic Simulations and Crack-Bridging Model

Understanding the Effect of Grain Boundaries on the Mechanical Properties of Epoxy/Graphene Composites

Nanostructure and damage characterisation of bitumen under a low cycle strain-controlled fatigue load based on molecular simulations and rheological measurements

A multi-scale analysis on reinforcement origin of static and dynamic mechanics in graphene-elastomer nanocomposites

Mechanical Performance of Graphene/polymethyl-Methacrylate Nano-Composites under Tension Loads: A Coarse-Grained Molecular Dynamic Simulation

Multiscale Investigation on Bitumen-Aggregate Interfacial Debonding Using Molecular Dynamics and Finite Element Method

Microstructure and Mechanical Performance of Graphene Reinforced Cementitious Composites

Revealing the Effect of Defects on the Interfacial Interactions of Pristine Graphene Modified Asphalt Via Molecular Dynamic Simulations and DFT Calculations

Characterization of Bitumen Micro-Mechanical Behaviors Using AFM, Phase Dynamics Theory and MD Simulation

Unraveling the Effects of Geometrical Parameters on Dynamic Impact Responses of Graphene Reinforced Polymer Nanocomposites Using Coarse-Grained Molecular Dynamics Simulations

Modeling damage evolution of graphene/aluminum composites considering crystal cracking and interface failure