Abstract:Following renewable energy development, batteries are the most crucial way to establish an energy storage system. In the past hundred years, lead-acid batteries have been widely applied in industrial and vehicle applications. Their low cost, simple manufacturing, and good safety can compete with lithium-ion batteries. However, some challenges still exist, e.g., poor low-temperature performance and short cycle life; aqueous solution is the reason that oxygen evolves from positive electrodes, resulting in positive active material detached from the electrode. Thus, developing novel lead-ion batteries to replace lead-acid batteries is a significant issue. In metal-ion batteries research, deep eutectic solvent (DES) has been well developed in recent years due to its high thermal stability and wide electrochemical window. Herein, a new Al/Pb bimetallic eutectic electrolyte (BEE) composed of aluminium perchlorate (Al(ClO 4 ) 3 ·9H 2 O), lead perchlorate (Pb(ClO 4 ) 2 ·3H 2 O), and succinonitrile (SN) with acetonitrile (ACN) as an additive, mixing in molar ratio. To realize the medium effect in this electrolyte, the BEE is compared with concentrated Pb(ClO 4 ) 2 aqueous solution. The ion conductivity, viscosity, and thermal stability depend on the metallic salt/SN ratio, and we proposed that the optimized molar ratio is 1:1:12:5. It exhibits outstanding thermal stability within − 50 to 50 °C. From Fourier-transform infrared spectroscopy (FTIR) spectrum analysis in BEE, the O-H stretching decreased, and the ClO 4 - stretching band increased, compared to the concentrated Pb(ClO 4 ) 2 aqueous solution; it can be understood that O-H interaction between Pb 2+ and ClO 4 - is weakened; meanwhile, ClO 4 - ions participated in first solvation shell. This variation reduces the desolvation energy of Pb 2+ to facilitate smoother lead plating/stripping and enables better electrochemical performance. To validate the effect of the solvation structure variation, assembling the Pb/Pb symmetric cell and Pb/Platinum (Pt) asymmetric cell are essential methods. Pb/Pb cell maintains a stable voltage hysteresis of about 20 mV even cycling 2500 h at the current density of 0.5 mA cm -2 , Pb/Pt cell under galvanostatic conditions successfully performs highly reversible Pb plating/stripping, achieved average coulombic efficiency (ACE) >99.96% in BEE for more than 1000 h at current density 0.5 mA cm -2 . Furthermore, we utilize BEE in Na 3 V 2 (PO 4 ) 3 (NVP) and natural graphite (NG) as cathode material; the reversible Pb 2+ and ClO 4 - (de-)intercalation are respectively observed in Pb/NVP and Pb/NG full cell, Pb/NVP cell exhibited long-term cycling stability with 80.95% capacity retention and 98.21% ACE after 600 cycles at a current density of 100 mA g -1 , then Pb/NG cell remains high discharge voltage plateau (≈1.7V) with 72% capacity retention after 200 cycles at a current density of 100 mA g -1 . Electrochemical impedance spectroscopy (EIS) of Pb/NVP in BEE-1:1:12:0 and 1:1:12:5 shows that adding the ACN additive can decrease the solution resistance (R s ) and charge transfer resistance (R ct ) of the cell. Ex-situ X-ray photoelectron spectroscopy (XPS) was performed on the Pb surface at the charging state, observing that Al species are co-deposited, revealing the synergistic effect between Aluminium perchlorate and Lead perchlorate. From the ex-situ X-ray diffraction (XRD) patterns of cycled NVP and NG cathode at charge/discharge states, some irreversible variation of peak position occurred, indicating that ion (de-)intercalation after operation; these results demonstrate BEE performed bi-functional ion (Pb 2+ and ClO 4 - ) intercalation phenomenon. To further confirm the Pb 2+ dynamic in the NVP cathode at charge/discharge progress, the X-ray absorption spectroscopy (XAS) characterization was applied. The comparison of XANES spectra collected at the V K-edge, the XANES shift to lower energy during discharging, this exhibition is consistent with reduction reaction of V 4+ to V 3+ , the EXAFS spectra show the local structure change of V-P/Na/Pb bonds. The EXAFS spectra at the Pb L III -edge indicated that the Pb-O distance is shortened during discharging; the abovementioned results demonstrate the Pb 2+ (de-)intercalation process in the NVP structure. In conclusion, this work proposed a novel bimetallic eutectic electrolyte for potential lead-ion batteries that enables stable Pb plating/stripping. The cycle-life and capacity retention of Pb/NVP and Pb/NG full-cell with BEE is significantly improved by adding acetonitrile (ACN) additive. The XAS characterization further confirmed the (de-)intercalation of Pb 2+ in the NVP cathode. A stable, high-voltage, and high-capacity positive electrode is needed, allowing the reuse of secondary lead metal to be applied to next-generation energy storage. Figure 1

Electrical double layer at the interface of a Pb electrode with propylene carbonate solutions

Measuring Double Layer Charging Via Droplet Approach Technique

Measurement of Electric Double Layer Capacitance Using Dielectrophoresis-Based Particle Manipulation.

How the Nature of the Alkali Metal Cations Influences the Double-Layer Capacitance of Cu, Au, and Pt Single-Crystal Electrodes

Salt Distribution, Phase Structure, and Conductivity of Poly(ethylene Oxide)-Block-poly(n-butyl Acrylate) Block Copolymer Electrolytes with Double Conductive Phases

Classical Models of the Interface between an Electrode and an Electrolyte

Organic double-layer capacitor with high surface area electrodes

Double Layer of Platinum Electrodes: Non-monotonic Surface Charging Phenomena and Negative Double Layer Capacitance.

Impedance spectroscopic study on interfacial ion transfers in cyanide-bridged coordination polymer electrode with organic electrolyte

Electrochemical Characterization of Single Layer Graphene/Electrolyte Interface: Effect of Solvent on the Interfacial Capacitance

How microstructures, oxide layers, and charge transfer reactions influence double layer capacitances. Part 1: impedance spectroscopy and cyclic voltammetry to estimate electrochemically active surface areas (ECSAs)

Electrode Polarization in Glassy Electrolytes: Large Interfacial Capacitance Values and Indication for Pseudocapacitive Charge Storage

Measurement of Electric Double Layer Charging Dynamics on Platinum Electrodes in Aqueous Solutions of Alkali Sulfates and Nitrates

Electrochemical Capacitance of CO-terminated Pt(111) is Dominated by CO-Solvent Gap

Modeling of electric double layer at solid-liquid interface with spatial complexity

Probing the Electric Double Layer Structure at Nitrogen-Doped Graphite Electrodes by Constant-Potential Molecular Dynamics Simulations

Extended Cycle Life Pb-Ion Batteries with High Coulombic Efficiency Exceeding 99.96% from Al/Pb Bimetallic Eutectic Electrolyte

Constant potential energetics of metallic and semiconducting electrodes: A benchmark study on 2D materials

Impedance Study of the Interface Between Lithium, Polyaniline, Lithium-Doped MnO2 and Modified Poly(ethylene Oxide) Electrolyte

Investigation on characteristics of anodic film formed on PbCaSnCe alloy in sulfuric acid solution

Properties of aqueous electrolyte solutions at carbon electrodes: effects of concentration and surface charge on solution structure, ion clustering and thermodynamics in the electric double layer