Abstract:There is a rapid progression toward spacecraft miniaturization due to the prospect of reduced launch costs, the requirement for satellite constellations, and the integration of microelectromechanical systems (MEMS). Satellite propulsion is required for increased mission flexibility and orbital debris mitigation, but down-scaling of such devices has proven non-trivial. Some electrostatic thrusters are both challenging and promising given their increase in performance with small geometry, but the relatively low thrust produced through ion acceleration limits their mission applicability. For this reason, it may be desirable to produce thrusters that are able operate across a wide range of specific impulses, depending on maneuver time, thrust bit requirements, and several other factors that influence propulsion system selection. At RAPPEL, a bimodal thruster that can operate at high specific impulse with electrospray propulsion or high thrust using cold gas expansion has been developed. Inevitably, such a propulsion system comes with complications related to performance characterization. A novel and economical data acquisition system has been established to measure the performance of both modes in high vacuum. For the cold gas mode, a torsional thrust balance was built in-house to measure thrust levels between 1 − 15 m N , and can be easily modified for lower ranges. The natural frequency of the thrust stand was measured to be 5.6 H z . The vacuum system sustained pressures below 5 m b a r while the cold gas nozzle operated, and 1.3 × 10 − 5 m b a r during electrospray operation. A 3-D printed linear cold gas nozzle was used to validate the thrust stand. Its thrust was close to 9 m N at a mass flow rate of 20 m g / s of nitrogen, producing a specific impulse of just under 45 s . Due to the noise present in thrust stand measurements at the sub- m N force-level produced by electrosprays, the thrust stand was built to also accommodate a complementary ion beam current measurement system. The power processing unit, used to generate square-wave ± 2500 V signals using optodiodes, was built to operate a bipolar ionic liquid ion source (ILIS). The rise and fall times of the push/pull switch were close to 1 m s and 30 m s , respectively. The electrical power system used to operate the electrospray and measure its performance is examined in detail, followed by the results from validation of both data acquisition systems.

Measuring thrust and predicting trajectory in model rocketry

Model Rocket Project for Aerospace Engineering Course: Trajectory Simulation and Propellant Analysis

Micro Thruster Measurement Using Pendulum System And Interferometry

Rocket motion

Monte-Carlo Based Lateral Thruster Parameters Optimization for 122 mm Rocket

Thrust control system design of ducted rockets

Accurate Measurements of Free Flight Drag Coefficients with Amateur Doppler Radar

Another Look at Rocket Thrust

Force Analysis and Simulation of Et Vane of Thrust-Vector

Unconstrained measurement method and verification of thrust vector in small solid propulsion system

Flight and bounce of spinning sports balls

Low Thrust Trajectory Design Using A Semi-Analytic Approach

Rocket Roll Dynamics and Disturbance — Minimal Modelling and System Identification

Micro-thrust Force Measurement Method Using Series Connected Double Elastic Elements

Aerodynamic Characterization of a Hypersonic Projectile Using Acceleration-Based Measurements and Numerical Methods

Research On Colloid Thruster And Thrust Measurement System

Effect of Thrust on Aeroelastic Stability of a Slender Missile

An Investigation into Active Control for Accessible Orbital Flight

A Novel Thrust Force Test Method for a Class of Precision Noncontact Linear Motion Actuators

Investigating Systematic Uncertainty and Experimental Design with Projectile Launchers

Development of a microthrust balance and ion beam measurement system: Characterizing a dual-mode thruster for spacecraft