Abstract:Tremendous efforts are being pursued by experimentalists worldwide in the designing of cryostats to minimize the most dominant radiation heat load over the cryogenic liquid kept inside it. These endeavors are imperative to secure the safe, consistent, and reliable performance of detectors, notably for experiments delving into the investigation of rare physics events, particularly those moving towards ton-scale capacities. In these experiments, maintaining a stable temperature of the cryogenic liquid is crucial. This stability helps in minimizing thermal noise and reducing the loss of cryogenic liquid by mitigating its evaporation rate, and this can be accomplished by reducing the ambient heat load coming from the outer hot wall towards the inner cold wall of the cryostat. Current work scrutinized the impacts of having no insulation, a single-layer insulation, and Multilayer Insulation (MLI) techniques on thermal protection from environmental heat loads at the cryostat's cold wall boundary, with a particular emphasis on the effectiveness of a single-layer insulation strategy against radiative heat load , a key precursor to MLI technology. The effectiveness of single-layer insulation was quantitatively analyzed for reducing heat load in large-scale rare event searches, using GERDA as an illustrative example and focusing on an optimized configuration. Performance metrics include ambient temperature, cryogenic liquid, emissivity, and the placement of insulation for optimal efficiency. The incorporation of a single intermediate layer positioned near the cold wall boundary results in a significant heat load reduction of 57% for the GERDA geometry compared to a scenario without such a layer. A feasible decrease in emissivity from the customary O (0.01) for insulation materials down to O (0.001–0.0001) could bring about substantial reductions in heat load, potentially by factors spanning approximately 8 to 90. In the scenario involving liquid helium (4.15 K), for example, as the ambient temperature surrounding the cryogen is lowered to (200, 150, 100, 50) K from room temperature, the heat load diminishes by 80%, 94%, 98.8%, and 99.9%, respectively. Moreover, optimally positioning single intermediate layer, crafted from ultra-radiopure material, as close as achievable to the cold wall boundary with minimal emissivity can yield a substantial reduction in heat load, estimated ∼ (40–60)%, thereby diminishing the evaporation rate of the cryogenic liquid.

Powering via Cooling Pipes: an Optimized Design for an SLHC Silicon Tracker

Evaporative CO2 cooling using microchannels etched in silicon for the future LHCb vertex detector

A new cold cooling system using krypton for the future upgrade of the LHC after the long shutdown 4 (LS4)

Study on a Cascade Pulse Tube Cooler with Work Recovery

Numerical Simulation and Experimental Verification of Dynamic Cooling and Temperature Control of the Optical Cavity in a Co2 Isotope Analyzer

Lightweight Thermal Management Strategies for the Silicon Detectors of CBM at FAIR

Design, fabrication and validation of an electrical conductivity principle based two-phase detection sensor array for molten lead (Pb) based heavy metal coolants up to 600^∘C

The Power Supply System of the CLEO III Silicon Detector

Integration of thermo-electric coolers into the CMS MTD SiPM arrays for operation under high neutron fluence

A novel scheme of the zero-liquid-helium-consumption cryostat for superconducting wigglers

Phase Difference Function in Coherent Temporal-spatial Region and Unified Equations of Steady, Non-steady Interference

Final Cooling With Thick Wedges for a Muon Collider

200 mm sensor development using bonded wafers

Characterisation of silicon microstrip detectors for the ATLAS Phase-II Upgrade with a micro-focused X-ray beam

Low Noise Cold Electronics System for SBND LAr TPC

Potential of thermal protection improvements in large-scale cryostat development

A LN$_2$ Based Cooling System for a Next Generation Liquid Xenon Dark Matter Detector

Study of Built-in Amplifier Performance on HV-CMOS Sensor for the ATLAS Phase-Ii Strip Tracker Upgrade

Performance of a Highly Granular Scintillator-SiPM Based Hadron Calorimeter Prototype in Strong Magnetic Fields

Investigation of HV/HR-CMOS Technology for the ATLAS Phase-II Strip Tracker Upgrade

The Silicon Sensors for the High Granularity Calorimeter of CMS