Quantum Measurements with Dynamically Bistable System

M. I. Dykman
DOI: https://doi.org/10.48550/arXiv.0810.5016
2008-10-28
Abstract:Periodically modulated nonlinear oscillators often display bistability of forced vibrations. This bistability can be used for new types of quantum measurements. They are based on switching between coexisting vibrational states. Since switching is accompanied by a large change of the amplitude and phase of forced vibrations, the measurements are highly sensitive. Quantum and classical noise plays dual role. It imposes a limitation on sensitivity in the familiar regime of a bifurcation amplifier. On the other hand, it makes it possible to use a bistable modulated oscillator in a new regime of a balanced dynamical bridge. We discuss the switching probabilities and show that they display scaling with control parameters. The critical exponents are found for different types of bifurcations and for different types of noise.
Mesoscale and Nanoscale Physics,Statistical Mechanics
What problem does this paper attempt to address?
The problem that this paper attempts to solve is: how to use dynamic bistable systems (such as periodically - modulated non - linear oscillators) for new - type quantum measurements. Specifically, the paper explores the quantum - activated decay mechanisms of these systems near bifurcation points and studies their potential applications in quantum measurements. ### Core of the problem 1. **Characteristics of dynamic bistable systems**: - The paper discusses that periodically - modulated non - linear oscillators often exhibit the bistable phenomenon of forced vibrations. - Bistability means that the system can exist between two different vibration states and can switch between these states. 2. **New methods of quantum measurement**: - Use the switching between vibration states in bistable systems to conduct high - sensitivity quantum measurements. - This switching is accompanied by significant changes in the amplitude and phase of forced vibrations, so the measurement is very sensitive. 3. **Influence of noise**: - Quantum and classical noise play a dual role in the measurement: - In the traditional bifurcation amplifier mode, noise limits the sensitivity. - However, in the new balanced dynamic bridge mode, noise makes it possible to use bistable - modulated oscillators. 4. **Theoretical analysis and experimental verification**: - The paper conducts a theoretical analysis of the switching probability and shows their scaling relationship with control parameters. - Critical exponents under different types of bifurcations and noise are found. ### Specific problem description - **How to improve the sensitivity of quantum measurement**: By using the significant changes in vibration states in bistable systems, achieve measurements with a high signal - to - noise ratio. - **Understand the quantum - activation mechanism**: Study the energy - scaling relationship of quantum - activated decay and its temperature dependence when approaching the bifurcation point. - **Develop new measurement modes**: Propose and verify a quantum measurement method based on the balanced dynamic bridge to achieve more accurate and rapid measurements. ### Main contributions - A new method for quantum measurement using dynamic bistable systems is proposed. - The mechanism of quantum - activated decay and its performance under different conditions are analyzed in - depth. - The influence of noise on measurement performance is explored and an improvement plan is proposed. By solving these problems, the paper provides a theoretical basis and experimental guidance for the future development of high - performance quantum measurement technologies.