Abstract:We present a Kalman filter-based approach for estimating external forces and torques relying on a dynamic model of a serial-chain robotic manipulator where only motor signals (currents, joint angles, and joint speeds) are measurable. The method does not require any additional sensing compared to standard robot control systems. The approach exploits redundancy in 7DOF arms, but also applies to traditional 6DOF manipulators. Automatic filter calibration routines are presented minimizing the number of parameters that must be tuned in order to successfully apply the proposed scheme and to optimize estimation quality. The approach is verified by measurement data gathered from an ABB YuMi, a dual-arm collaborative robot with 7DOF each arm. Furthermore, measurement results are presented employing force and torque estimates in a compliance control scheme, verifying that the estimation quality achieved is improved compared to existing approaches and is sufficient to employ the estimates in force-controlled applications.Note to Practitioners—More and more robotic applications involve contact with at least partially unknown environments. As a consequence, they require control approaches that go beyond the traditional position control. In particular, information about contact forces and torques has to be taken into account. However, integrating additional sensing equipment to obtain the required force/torque information is often technically challenging and expensive. Cartesian contact force and torque estimation allows obtaining force/torque information solely from available sensors. The estimation technique can be regarded as a virtual sensor, and hence this brief deals with a key technology enabling force controlled robotic applications such as assembly, grinding, and deburring without the need for expensive additional sensing.

A Vision-based Computed Torque Control for Parallel Kinematic Machines

Dynamic Modeling and Contouring Control of Parallel Kinematic Machines

Dynamics and contouring control of a 3-DoF parallel kinematics machine

Visual Servo Kinematic Control For Robotic Manipulators

Kinematics-based Incremental Visual Servo for Robotic Capture of Non-Cooperative Target.

Incremental Visual Servo Control of Robotic Manipulator for Autonomous Capture of Non-Cooperative Target

Incremental Inverse Kinematics Based Vision Servo for Autonomous Robotic Capture of Non-Cooperative Space Debris

Mechatronic Model Based Computed Torque Control of a Parallel Manipulator

Kinematic Analysis of a New Parallel Machine Tool: the Orthoglide

A Realistic Model Reference Computed Torque Control Strategy for Human Lower Limb Exoskeletons

Kinematic Analysis and Trajectory Planning of the Orthoglide 5-axis

Modeling and vision-based control of large-dimension cable-driven parallel robots using a multiple-camera setup

Dynamic Control of Cable Driven Parallel Robots with Unknown Cable Stiffness: a Joint Space Approach

Torque Feedforward Control of the Parallel Spindle Head Feed Axes

An Experimental Investigation of the Dynamic Performances of a High Speed 4-DOF 5R Parallel Robot Using Inverse Dynamics Control

Geometric model-based joint angle selection criterion for force parameter identification & Decoupling control method of position and posture in shaft-hole assembly

Object Manipulation Of Humanoid Robot Based On Combined Optimization Approach

Design of Kinematic Controller for Real-Time Vision Guided Robot Manipulators

Analysis And Control For A New Reconfigurable Parallel Mechanism

Flatness Based Control of an Industrial Robot Joint Using Secondary Encoders

Motor-Current-Based Estimation of Cartesian Contact Forces and Torques for Robotic Manipulators and Its Application to Force Control