Abstract:X-ray scattering during the previous 15 years has radically changed our view of molecular ordering in organic monolayers at the water-vapor interface. A partial motivation for those studies has been to understand molecular ordering in biological membranes. These bilayer lipid membranes exist at liquid-liquid interfaces and consist of molecules that are slightly soluble in the surrounding aqueous medium. As a result, biomembranes are believed to be disordered, possibly significantly more so than their counterparts at the water-vapor interface. As one approach to understanding the molecular ordering in organic assemblies at the liquid-liquid interface, we recently pioneered the use of xray scattering to study the structure of monolayers at the water-oil interface [1]. Initially, we chose to study fluorinated surfactants at the water-hexane interface partially because of the large electron density contrast. Here, we report studies of n-alcohol monolayers at the water-hexane interface. Although this system has much smaller x-ray contrast, it contains surfactants much closer in composition to biological lipids. Samples are prepared by placing a bulk solution of an n-alcohol in hexane on top of bulk water, (the four alcohols used in this study are CH 3 (CH 2 ) m -1 OH, where m = 20, 22, 24, and 30, referred to as C m OH in this article). We study the interface between these two bulk solutions. Previous thermodynamic measurements have shown that the interface undergoes a transition as a function of temperature [2-4]. This is illustrated in Fig. 1, which shows our measurements of interfacial tension γ as a function of temperature for our four systems and for the pure water-hexane interface. The slope, –dγ /dT, is the surface excess entropy. The sharp change in slope reveals an interfacial transition. We have chosen the bulk concentration of C m OH so that the transition is at a convenient temperature. X-ray reflectivity from these interfaces is measured with the liquid surface spectrometer at NSLS beamline X19C [5] using techniques specific to the liquid-liquid interface described previously [1, 6]. Figure 2 shows the reflectivity normalized to the Fresnel reflectivity (for an ideal interface without structure), R/R F , as a function of the wave vector transfer normal to the interface (Q z = (4π/ λ) sinθ, where θ is the angle of specular reflection and λ =0.825 Å). For each of the four systems studied, Fig. 2 shows the measured and fitted R/R F for two temperatures, one far below and the other far above the transition temperature. The data in Fig. 2 for samples below the transition temperature have an oscillation whose period decreases as the alcohol chain length increases. This indicates that the thickness of the alcohol monolayer increases with chain length, as expected. The lines in Fig. 2 that fit these oscillations are derived from a standard fitting procedure using the Born approximation along with a model for the interfacial profile that consists of 2 or 3 layers sandwiched between bulk water and hexane [7]. The interface between each of these layers and an adjacent layer (or bulk) is roughened by capillary waves with a roughness value calculated from the measured interfacial tensions in Fig. 1. The fitting parameters consist only of the electron density of each layer and the layer’s thickness. One expects that an ordered monolayer will be described by a two layer model: the layer next to bulk water would represent the electron density at the position of the head group (COH), the adjacent layer (next to the bulk hexane) would represent the electron den-

Structure and Depletion at Fluoro- and Hydro-carbon/Water Liquid/Liquid Interfaces

Atomic Force Microscopy Study of Non-DLVO Interactions Between Drops and Bubbles.

Structure and Hydrogen Bonds of Hydrophobic Deep Eutectic Solvent-Aqueous Liquid-Liquid Interfaces

Hydration and dewetting near fluorinated superhydrophobic plates.

Water Structure and Electric Fields at the Interface of Oil Droplets

Molecular Dynamics Simulation of Distribution and Diffusion Behaviour of Oil–Water Interfaces

Interfacial behaviour of short-chain fluorocarbon surfactants at the n-hexane/water interface: a molecular dynamics study

X-ray Scattering from n-alcohol Monolayers at the Water-hexane Interface

Monte Carlo simulations probing the liquid/vapour interface of water/hexane mixtures: adsorption thermodynamics, hydrophobic effect, and structural analysis

Molecular structure and hydrophobic solvation thermodynamics at an octane–water interface

The Effects of External Interfaces on Hydrophobic Interactions I: Smooth Surface

Quantifying the Hydrophobic Effect per CF2 Moiety from Adsorption of Fluorinated Alcohols at the Water/Oil Interface

Intrinsic water layering next to soft, solid, hydrophobic, and hydrophilic substrates

Direct Observation of Oil Displacement by Water Flowing Toward an Oil Nanogap

Long-Range Attraction between Graphene and Water/Oil Interfaces

Water Structure at Hydrophobic Interfaces Studied by Sum-Frequency Generation

Probing the Interaction Mechanism between Alkanes and Hydrophobic Substrate Using Atomic Force Microscopy and Molecular Dynamics Simulation

Effect of Hydro-Oleophobic Perfluorocarbon Chain on Interfacial Behavior and Mechanism of Perfluorooctane Sulfonate in Oil-Water Mixture

Molecular modeling of interfacial properties of the hydrogen+water+decane mixture in three-phase equilibrium

Surface Forces in the Thin Liquid Films (TLFs) of Water Confined between n-Alkane Drops and Hydrophobic Gold Surfaces