Abstract:We investigate the characteristics and noise performance of rf Superconducting Quantum Interference Devices (SQUIDs) by solving the corresponding Langevin equations numerically and optimizing the model parameters with respect to noise energy. After introducing the basic concepts of the numerical simulations, we give a detailed discussion of the performance of the SQUID as a function of all relevant parameters. The best performance is obtained in the crossover region between the dispersive and dissipative regimes, characterized by an inductance parameter \beta_L'\equiv 2\pi L I_0/\Phi_0\approx 1; L is the loop inductance, I_0 the critical current of the Josephson junction, and \Phi_0 the flux quantum. In this regime, which is not well explored by previous analytical approaches, the lowest (intrinsic) values of noise energy are a factor of about 2 above previous estimates based on analytical approaches. However, several other analytical predictions, such as the inverse proportionality of the noise energy on the tank circuit quality factor and the square of the coupling coefficient between the tank circuit and the SQUID loop, could not be well reproduced. The optimized intrinsic noise energy of the rf SQUID is superior to that of the dc SQUID at all temperatures. Although for technologically achievable parameters this advantage shrinks, particularly at low thermal fluctuation levels, we give an example for realistic parameters that leads to a noise energy comparable to that of the dc SQUID even in this regime.

Input Impedance and Gain of a Gigahertz Amplifier Using a DC SQUID in a Quarter Wave Resonator

High-gain weakly nonlinear flux-modulated Josephson parametric amplifier using a SQUID-array

Simple, High Saturation Power, Quantum-limited, RF SQUID Array-based Josephson Parametric Amplifiers

Fabrication and Characterization of the Superconducting Quantum Interference Device Amplifier with Washer Type Input Coil

Superconducting microstrip amplifiers with sub-Kelvin noise temperature near 4 GHz

A widely tunable parametric amplifier based on a SQUID array resonator

Kinetic inductance traveling wave amplifier designs for practical microwave readout applications

Microwave Amplification Based on Quasiparticle SIS Up and Down Frequency Converters

Development of a dc-SQUID Amplifier with Intra-Coil Resistors

Improved microwave SQUID multiplexer readout using a kinetic-inductance traveling-wave parametric amplifier

A femto-Tesla DC SQUID design for quantum-ready readouts

Reverse isolation and backaction of the SLUG microwave amplifier

Two-terminal Wide Range SQUID Amplifier with Hysteretic Quasi Linear Transfer Characteristics

Simulation of a flux-pumped Josephson parametric amplifier with a detailed SQUID model using the harmonic balance method

Low-noise cryogenic microwave amplifier characterization with a calibrated noise source

A Numerical Treatment of the Rf SQUID: I. General Properties and Noise Energy

Bandwidth and Aliasing in the Microwave SQUID Multiplexer

A three-wave mixing kinetic inductance traveling-wave amplifier with near-quantum-limited noise performance

Fabrication and Characterization of Aluminum SQUID Transmission Lines

Characterization of a low-noise superconductor–insulator–superconductor-based microwave amplifier with local oscillator phase-adjusting architecture

Modulation Depth of Series SQUIDs Modified by Josephson Junction Area*