Low-cost, reliable and flexible piezoresistive pressure sensors coated with single layer graphene and silver nanowires on three-dimensional polyurethane sponge

Yi Sun,Kai Liu,Fan Bu,Ruijie Meng,Guoqing Xie,Ke Guo,Aodong Cao,Lexi Tu
DOI: https://doi.org/10.1016/j.sna.2024.115524
IF: 4.291
2024-06-03
Sensors and Actuators A Physical
Abstract:Flexible wearable sensors perform a significant role in practical applications such as medical monitoring, rehabilitation exercises, and artificial skin, as they can quantify and visualize external stress and strain. Polyurethane (PU) sponge stands out as a highly elastic and reproducible material frequently employed as a substrate in flexible electronic devices. Sponge materials with different pore sizes and densities exhibit varying degrees of deformation resistance under long-term cyclic pressure, thereby affecting the performance of sensors. Herein, piezoresistive pressure sensors based on PU with different pore diameters were successfully fabricated by dip-coating technology. By incorporating silver nanowires (AgNWs) and single layer graphene (SLG) into the sponge, both the low-density and high-density composite sponges can withstand over 70% compressive strain, with stresses of 62.57 kPa and 31.79 kPa, respectively. Moreover, high-density composite sponge demonstrates a more stable conductive structure, more consistent relative resistance and better flame-retardant performance. The response and recovery time between 10% and 40% strains of the resulting pressure sensor based on high-density composite sponge (PU@AgNWs@SLG) are 110 ms and 106 ms and its gauge factor reaches 2.39. The pressure sensor exhibits a satisfactory reproducibility after over 3000 compression-release cycles, and performs during various applications, such as controlling brightness of LEDs, monitoring human activities, sensing finger movements.
engineering, electrical & electronic,instruments & instrumentation
What problem does this paper attempt to address?