An Ultrahigh Power Density and Ultralow Wear GaN‐Based Tribovoltaic Nanogenerator for Sliding Ball Bearing as Self‐Powered Wireless Sensor Node

Zhi Zhang,Ning Wu,Likun Gong,Ruifei Luan,Jie Cao,Chi Zhang

DOI: https://doi.org/10.1002/adma.202310098

IF: 29.4

2023-12-01

Advanced Materials

Abstract:The tribovoltaic effect is regarded as a newly discovered semiconductor effect for electromechanical energy conversion. However, tribovoltaic nanogenerators (TVNGs) are widely limited by low output power and poor wear resistance for device integration and application. Here, we invent a TVNG using a ball‐on‐disk structure composed of gallium nitride (GaN) and steel ball. It exhibits an open‐circuit voltage exceeding 130 V and an ultrahigh normalized average power density of 24.6 kW m−2 Hz−1, which is a 282‐fold improvement compared to previous works. Meanwhile, this TVNG reaches an ultralow wear rate of 5×10−7 mm3 N−1 m−1 at a maximum contact pressure of 906.6 MPa, surpassing the TVNG composed of Si by three orders of magnitude due to the local ultrahigh stress and concentrated injection of frictional energy. Based on the TVNG, we construct the first tribovoltaic bearing consisting of steel balls, a retaining frame, a GaN ring, a seat ring, and a shaft ring. By integrating a management circuit, a transmission module, a relay, and receiving terminals, we achieve a sensing signal transmission in 16 seconds at 300 rpm, enabling the monitoring of ambient pressure and temperature. This work not only realizes a GaN‐based TVNG with high‐performance and low wear simultaneously, but also achieves frictional energy harvesting for industrial bearings, demonstrating great potential for intelligent components and self‐powered sensor nodes in the industrial Internet of Things. This article is protected by copyright. All rights reserved

materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,nanoscience & nanotechnology