Abstract:With the development of ultra-precision machining technology, parts with microstructures on the surface are playing an increasingly important role in engineering practice. The scanning interference microscope measurement method is widely used in the measurement of microscopic surface topography. This paper proposes a method of interference microscopy combined with subaperture stitching. The first step is to divide and measure the sub-aperture. There is a partial overlap area between the divided adjacent subapertures. The white light interferometer measures each sub-aperture in turn. The second step is edge feature detection. There are highly steep edge features between the bottom of the groove and the surface of the surface microgroove. The stitching algorithm detects edge features by detecting the slope threshold of the sub-aperture. The third step is to correct the abscissa. Project the detected edge feature data onto the OXY plane to generate a 2D data set. The multi-dimensional motion scanning platform inevitably has motion errors in the measurement process, so the edge characteristic curves of adjacent sub-apertures have obvious lateral displacement in the overlapping area. The lateral displacement and angle of the lateral coordinate of each sub-aperture are corrected by the least square method. The fourth step is the height coordinate correction. The stitching algorithm minimizes the height difference between the corresponding points in the overlapping area, and solves it with a linear least squares problem model. We have completed the measurement of the fringe pattern on the computer-generated hologram (CGH) substrate and the complete topography of the long groove on the 10mm hemisphere. After the sub-aperture global iterative stitching algorithm, there is no stitching trace in the simulation result. For the long groove on the hemisphere, we designed a four-dimensional scanning motion platform and a special fixture to ensure that the long groove on the hemisphere rotates around an axis perpendicular to the geodesic line. The center of the white light interference fringe is always at the center of the long slot aperture.

Three-Dimensional Topography of High-Aspect Ratio Trenches by Sample-Induced Aberration-Compensable Coherence Scanning Interferometry

Advances of Confocal Microscopy in Three-Dimensional Surface Topography Measurement

Long Range Topography by Dispersion Unmatched Spectral-Domain Interferometry Based on Virtually Imaged Phased Array Modes

Topography reconstruction of high aspect ratio silicon trench array via near-infrared coherence scanning interferometry

Long Range And Accurate Measurement Of Deep Trench Microstructures By A Specialized Scanning Tunneling Microscope

Ultra-deep three-dimensional optical coherence tomography in turbid media

A novel scanning tunneling microscopy for long range and high aspect ratio measurement

Aspheric and Free-Form Surfaces Test with Non-Null Sub-Aperture Stitching

Two-Dimensional Structural Surface Measurement Based On Spectrally Resolved White-Light Interferometry

Adjustable low NA Quasi-Confocal reflectometry for ultra-high-aspect-ratio micro-structures

Rapid Measurement Of A High Step Microstructure With 90 Degrees Steep Sidewall

Non-integral depth measurement of high-aspect-ratio multi-layer microstructures using numerical-aperture shaped beams

Measurement of Sub-Surface Microstructures Based on a Developed Ultrasonic Atomic Force Microscopy

Sensitivity analysis of optical scatterometry technique for high aspect ratio trench measurement

Note: Symmetric Modulation Methodology Applied In Improving The Performance Of Scanning Tunneling Microscopy

Large Range Atomic Force Microscopy with High Aspect Ratio Micropipette Probe for Deep Trench Imaging

Frequency selective illumination for high aperture coherence scanning interferometry

Topography measurement and reconstruction of inner surfaces based on white light interference

A white-light interferometry method for 3D measurement of compactly spaced micro-nano structural units

High-resolution white light scanning stitching measurement of full-surface microstructure

Three-dimensional atomic force microscopy based on tailored cantilever probe with flared tip