Separation of Lithium Ion Cathode Material for Direct Recycling
Anton Zorin,Emma Kendrick
DOI: https://doi.org/10.1149/ma2021-02581697mtgabs
2021-10-19
ECS Meeting Abstracts
Abstract:In recent years there has been an acceleration in the use of lithium ion batteries (LiBs) in applications ranging from automotive to wearable technology. This means it is now more key than ever to be able to extract maximum use and then to recycle these batteries in a safe sustainable manner as they not only contain rare and critical elements but many of these elements are expensive and environmetaly damaging to extract and make into batteries and thus can cause a large amount of environmental damage1. A good way to prolong the life of some LiBs is to utilise them in 2nd life applications without any chemical treatment. 2nd life applications vary and can range from electric vehicle fast charger support2,3 to back up power4 and grid balancing support2,5, these 2nd life applications can extend the life of a battery by anywhere between 6 and 30 years2. Some batteries may not be re-used directly in second life applications due to capacity loss through degradation. Degradation can occur through a number of mechanisms including: electrolyte decomposition6, Loss of active lithium, and loss of active material porosity and interconectivity7, all of which lead to an increased impedance and losses in efficiencies. For these batteries a disposal route must be found. Currently for End of Life (EoL) batteries the disposal routes most commonly consist of either stock piling, which may be a potential environmental hazard, or pyrometallurgical processes that are not as environmentally friendly and do not necessarily recover the maximum value from the product. For quality control rejects no dedicated commercial recycling process is known about. One of the main hurdles to direct recycling of LiBs is the difficulty in separating active material from casing and current collector. In this work we investigate how two different commercial cathode chemistries are affected by two separation methods and compare these to their untreated equivalents. The first method comprises of an acid and ultrasonic agitation and the second comprises of the green solvent DMSO and ultrasonic agitation. We present data to investigate how particle morphology, crystal structure and metal content varies between the three methods. We then go on to remanufacture the materials into half cells and examine the capacity, electrochemical performance, and cycle life of the two processes. Harper, G. et al. Recycling lithium-ion batteries from electric vehicles. Nature 575, 75–86 (2019).Casals, L. C., Amante García, B. & Canal, C. Second life batteries lifespan: Rest of useful life and environmental analysis. J. Environ. Manage. (2019). doi:10.1016/j.jenvman.2018.11.046Sebastian, S. S. et al. Adaptive fast charging methodology for commercial Li‐ion batteries based on the internal resistance spectrum. Energy Storage 1–16 (2020). doi:10.1002/est2.141Pagliaro, M. & Meneguzzo, F. Lithium battery reusing and recycling: A circular economy insight. Heliyon 5, e01866 (2019).Gohla-Neudecker, B., Bowler, M. & Mohr, S. Battery 2nd life: Leveraging the sustainability potential of EVs and renewable energy grid integration. 5th Int. Conf. Clean Electr. Power Renew. Energy Resour. Impact, ICCEP 2015 311–318 (2015). doi:10.1109/ICCEP.2015.7177641An, S. J. et al. Correlation of electrolyte volume and electrochemical performance in lithium-ion pouch cells with graphite anodes and NMC532 cathodes. J. Electrochem. Soc. 164, A1195–A1202 (2017).Birkl, C. R., Roberts, M. R., McTurk, E., Bruce, P. G. & Howey, D. A. Degradation diagnostics for lithium ion cells. J. Power Sources 341, 373–386 (2017). Harper, G. et al. Recycling lithium-ion batteries from electric vehicles. Nature 575, 75–86 (2019). Casals, L. C., Amante García, B. & Canal, C. Second life batteries lifespan: Rest of useful life and environmental analysis. J. Environ. Manage. (2019). doi:10.1016/j.jenvman.2018.11.046 Sebastian, S. S. et al. Adaptive fast charging methodology for commercial Li‐ion batteries based on the internal resistance spectrum. Energy Storage 1–16 (2020). doi:10.1002/est2.141 Pagliaro, M. & Meneguzzo, F. Lithium battery reusing and recycling: A circular economy insight. Heliyon 5, e01866 (2019). Gohla-Neudecker, B., Bowler, M. & Mohr, S. Battery 2nd life: Leveraging the sustainability potential of EVs and renewable energy grid integration. 5th Int. Conf. Clean Electr. Power Renew. Energy Resour. Impact, ICCEP 2015 311–318 (2015). doi:10.1109/ICCEP.2015.7177641 An, S. J. et al. Correlation of electrolyte volume and electrochemical performance in lithium-ion pouch cells with graphite anodes and NMC532 cathodes. J. Electrochem. Soc. 164, A1195–A1202 (2017). Birkl, C. R., Roberts, M. R., McTurk, E., Bruce, P. G. & Howey, D. A. Degradation diagnostics for lithium ion cells. J. Power Sources 341, 373–386 (2017).