Abstract:A novel design for an inexpensive depth of interaction capable detector for gamma rays, suitable for nuclear medical applications, especially Positron Emission Tomography, has been developed. The design takes advantage of the strong correlation between the width of the scintillation light distribution in continuous crystals and the depth of interaction of the gamma-ray. For measuring the distribution width, an inexpensive modification of the commonly used charge dividing circuits that allows analogue and instantaneous computation of the 2nd moment has been developed and is presented in this work. The method has been tested with a detector made of a continuous LSO-scintillator of dimensions 42x42x10 cubic mm and optically coupled to the compact large area position sensitive photomultiplier H8500 from Hamamatsu. The mean resolution in all non-trivial moments was found to be smaller than 5% but their direct use as estimates for the three-dimensional photoconversion position turned out to be unsuitable. Standard polynomial interpolation in higher dimensions has been adopted to reconstruct the impact positions of the gamma-rays from the measured moments. When using the reconstructed impact positions, the intrinsic mean spatial resolution of the detector was found to be 1.9 mm for the transverse components and 3.9 mm for the depth of interaction. Using directly the bare moments as position estimate, the intrinsic mean spatial resolution of the detector was found to be 3.4 mm and 4.9 mm, respectively. The cost for the required detector improvements are essentially negligible.
What problem does this paper attempt to address?
The problem that this paper attempts to solve is to study the evolution of the concentration distribution over time in a subdiffusive system when a membrane separates a homogeneous solution from a pure solvent. Specifically, the author focuses on how to extract the parameters of the subdiffusive system from experimental data and verify the relationship between these parameters and the theoretical model.
### Main problems
1. **Scaling form of concentration distribution**: The author attempts to prove that in the long - time limit, the concentration distribution \(C\) can be expressed as a general scaling function:
\[
C \sim t^\lambda F\left(\frac{\delta}{t^\rho}\right)
\]
where \(\delta\) is the distance from the membrane surface, and \(\lambda\) and \(\rho\) are scaling parameters.
2. **Extraction of subdiffusion parameters**: By deriving the relationships between the subdiffusion parameters of the medium and the membrane and the scaling parameters \(\lambda\) and \(\rho\), the author hopes to extract the subdiffusion parameters from the experimental data. Specifically, these relationships are:
\[
\beta=\lambda + \rho
\]
\[
\rho=\frac{\alpha}{2}
\]
### Research background
Subdiffusive systems can be studied by the scaling method. Assume that the form of the concentration \(C(x, t)\) is:
\[
C(x, t)=t^\lambda F(z)
\]
where
\[
z \sim \frac{x - x_0}{t^\rho}
\]
Here \(x_0\) is an arbitrarily selected point (this paper considers a one - dimensional system). The scaling parameters \(\lambda\) and \(\rho\) are controlled by the subdiffusion parameters of the system and can be obtained by experimental measurement.
### Combination of experiment and theory
The author studied a system of two containers separated by a thick membrane, where one container contains a homogeneous solute and the other contains a pure solvent. Based on the theoretical model, the author shows that the concentration distribution can be described by the above - mentioned scaling function and derives useful formulas, combining the subdiffusion parameters of the membrane and the solvent with the scaling parameters \(\lambda\) and \(\rho\).
### Conclusion
Through theoretical analysis and experimental verification, the author finds that the concentration distribution does follow the form of the scaling function, and the subdiffusion parameters can be extracted from the experimental data. For example, in the agarose gel solvent system with a PEG 2000 membrane, the experimental measurements are \(\rho = 0.44\pm0.01\) and \(\lambda = 0.17\pm0.01\). Substituting these into the above relationships, the subdiffusion parameter \(\beta = 0.61\pm0.01\) within the membrane can be calculated.
In summary, this paper successfully combines the theoretical model with the experimental results, verifies the scaling behavior of the concentration distribution in the subdiffusive system, and provides a method for extracting subdiffusion parameters from experimental data.