Pumping Current in a Quantum Dot by an Oscillating Magnetic Field

Zhao Yang Zeng,Hong Li,Baowen Li

DOI: https://doi.org/10.1142/S0217979207045542

2007-04-18

Abstract:We investigate spin and charge current through a quantum dot pumped by a time-varying magnetic field. Using the density matrix method, quantum rate equations for the electronic occupation numbers in the quantum dot are obtained and solved in the stationary state limit for a wide set of setup parameters. Both charge and spin current are expressed explicitly in terms of several relevant parameters and analyzed in detail. The results suggest a way of optimizing experimental setup parameters to obtain an maximal spin current without the charge current flow.

Mesoscale and Nanoscale Physics

What problem does this paper attempt to address?

The problem that this paper attempts to solve is: **How to pump out current in quantum dots through a magnetic field that changes over time, especially optimizing experimental parameters to obtain the maximum spin current without an accompanying charge current**.

### Background and Problem Description

Spintronics is an emerging research field, aiming to effectively control the spin degree of freedom of electrons, not just their charge degree of freedom. A common method for generating spin current is to use semiconductor quantum dots. However, traditional spin currents are usually accompanied by charge currents, which generate heat and pose a serious challenge to the miniaturization and stability of microelectronic devices. Therefore, researchers hope to find a method of generating spin current without generating charge current.

### Research Content

In this paper, the authors studied the spin and charge currents pumped in quantum dots through a time - varying magnetic field. Specifically, they considered a quantum dot coupled to two electron leads and applied a vertical constant magnetic field \( B_0 \hat{z} \) and a transverse time - varying magnetic field \( B_{rf} [\cos(\omega_{rf} t) \hat{x} + \sin(\omega_{rf} t) \hat{y}] \). The role of these magnetic fields is to split the quantum dot energy levels into two spin - related energy levels through the Zeeman effect and pump the low - energy spin - up state electrons into the high - energy spin - down state through the oscillating magnetic field.

### Main Results

1. **Hamiltonian**:
The Hamiltonian of this system is:
\[
H = \sum_\sigma \varepsilon_\sigma d^\dagger_\sigma d_\sigma + \sum_{\alpha = l,r} \sum_k \varepsilon_{\alpha k \sigma} c^\dagger_{\alpha k \sigma} c_{\alpha k \sigma} + \sum_{\alpha = l,r} \sum_k t_{\alpha k \sigma} (c^\dagger_{\alpha k \sigma} d_\sigma + d^\dagger_\sigma c_{\alpha k \sigma}) + H_{rf}(t)
\]
where \( H_{rf}(t)=\frac{\Omega_R}{2}(d^\dagger_\uparrow d_\downarrow e^{i\omega_{rf} t}+d^\dagger_\downarrow d_\uparrow e^{-i\omega_{rf} t})\), and \(\Omega_R = \frac{g\mu_B B_{rf}}{2}\) is the Rabi frequency.

2. **Density Matrix Equation**:
Using the density matrix method, the authors derived the quantum rate equations describing the electron occupation numbers and solved them in the steady - state limit. These equations describe the transition probabilities between different states of the system.

3. **Current Expressions**:
Under steady - state conditions, the charge current \( I_c \) and spin current \( I_s \) can be expressed as:
\[
I^c_\alpha = I_{\alpha \downarrow} + I_{\alpha \uparrow} = e\Omega_R^2 (\Gamma_{l \uparrow} \Gamma_{r \downarrow}-\Gamma_{l \downarrow} \Gamma_{r \uparrow}) \Theta(E_Z,\Omega_R,\omega_{rf},T_\perp,\Gamma_{\alpha \sigma})
\]
\[
I^s_\alpha = I_{\alpha \downarrow}-I_{\alpha \uparrow} = e\Omega_R^2 (\Gamma_{l \uparrow} \Gamma_{r \downarrow}+\Gamma_{l \downarrow} \Gamma_{r \uparrow}) \Theta(E_Z,\Omega_R,\omega_{rf},T_\perp,\Gamma_{\alpha \sigma})
\]