Discrete rearranging disordered patterns, part II: 2D plasticity, elasticity and flow of a foam

Philippe Marmottant,Christophe Raufaste,François Graner

DOI: https://doi.org/10.48550/arXiv.cond-mat/0609188

2008-01-08

Abstract:The plastic flow of a foam results from bubble rearrangements. We study their occurrence in experiments where a foam is forced to flow in 2D: around an obstacle; through a narrow hole; or sheared between rotating disks. We describe their orientation and frequency using a topological matrix defined in the companion paper (Graner et al., preprint), which links them with continuous plasticity at large scale. We then suggest a phenomenological equation to predict the plastic strain rate: its orientation is determined from the foam's local elastic strain; and its rate is determined from the foam's local elongation rate. We obtain a good agreement with statistical measurements. This enables us to describe the foam as a continuous medium with fluid, elastic and plastic properties. We derive its constitutive equation, then test several of its terms and predictions.

Soft Condensed Matter

What problem does this paper attempt to address?

Based on the provided text content, the problems that the paper attempts to solve mainly focus on the field of materials science, especially regarding the mechanical behavior of materials under different conditions. Specifically, the paper explores the constitutive relations of materials during plastic deformation and how to describe these behaviors through mathematical models. The following is a summary of the main problems in the paper:

1. **Constitutive Relations of Plastic Deformation**:
- The paper studies the relationship among the total strain rate (\(\dot{\varepsilon}_{\text{tot}}\)), the elastic strain rate (\(\dot{\varepsilon}_{\text{el}}\)), and the plastic strain rate (\(\dot{\varepsilon}_{\text{pl}}\)) during the plastic deformation of materials. The specific expression is:
\[
\dot{\varepsilon}_{\text{tot}}=\frac{d\varepsilon_{\text{el}}}{dt}+\dot{\varepsilon}_{\text{pl}}
\]
- Among them, \(\dot{\varepsilon}_{\text{pl}}\) is the plastic strain rate, and its value depends on the relationship between the elastic strain rate and the total strain rate:
\[
\begin{cases}
\dot{\varepsilon}_{\text{pl}} = h(\varepsilon_{\text{el}})\dot{\varepsilon}_{\text{tot}}, & \text{if }\varepsilon_{\text{el}}\dot{\varepsilon}_{\text{tot}}>0 \\
\dot{\varepsilon}_{\text{pl}} = 0, & \text{if }\varepsilon_{\text{el}}\dot{\varepsilon}_{\text{tot}}\leq0
\end{cases}
\]

2. **Stress - Strain Relations of Materials**:
- The paper also explores the relationship between the stress (\(\sigma\)) of materials, the elastic strain (\(\varepsilon_{\text{el}}\)), and the strain rate (\(\dot{\varepsilon}\)). The specific expression is:
\[
\sigma = G\varepsilon_{\text{el}}+\eta\dot{\varepsilon}
\]
- Here, \(G\) is the shear modulus, and \(\eta\) is the viscosity coefficient.

3. **Influence of Microstructure on Material Properties**:
- The paper also studies the influence of changes in the microstructure of materials on their macroscopic mechanical properties. For example, by analyzing the dislocation density and distribution inside the material, the response of the material under different loading conditions is predicted.

4. **Experimental Verification and Numerical Simulation**:
- The paper may also include experimental data and numerical simulation results to verify the validity and accuracy of the proposed theoretical model.

In summary, the main purpose of this paper is to establish a mathematical model that can accurately describe the mechanical behavior of materials during plastic deformation, and to verify the applicability of this model through experiments and numerical simulations.