Efficient synthesis of chiral beta-arylisopropylamines by using catalytic asymmetric hydrogenation.
Jian Chen,Weicheng Zhang,H. Geng,Wei Li,G. Hou,A. Lei,Xumu Zhang
DOI: https://doi.org/10.1002/anie.200805058
2009-01-12
Angewandte Chemie
Abstract:Transition metal catalyzed asymmetric hydrogenation of enamides[1] is a powerful method to prepare chiral amines, which are important building blocks in organic synthesis.[2] With the development of many effective chiral ligands,[1] a variety of prochiral enamides such as 1,[3] 2,[3a,c,d,e,g] 3,[4] and 4,[5] have been hydrogenated in excellent enantioselectivities (Figure 1). However, asymmetric hydrogenation of 5 was rarely studied. To our knowledge, the only result was reported to give moderate enantioselectivity (50% ee) for the hydrogenation of 5a (Ar = Ph) with a Rh/DIPAMP complex.[6] In this paper, we prepared a series of enamides of both (Z)-5 and (E)-5 and tested them in Rh-catalyzed asymmetric hydrogenation with several chiral ligands. Excellent ee’s (up to 99% ee) have been achieved for those (Z)-configured enamide with Rh/TangPhos catalytic system.
Figure 1
Prochiral enamide substrates for asymmetric hydrogenation.
A number of methods for the preparation of enamides have been reported, including rearrangement reactions,[6, 7] reduction of nitro alkenes[8] or ketoximes,[9] acylation of imines,[10] and direct condensation of ketone and amide.[11] Recently, a Merck group has developed an efficient Pd-catalyzed amidation reaction leading to a diverse array of enamides.[12] Under optimized condition, good selectivity for (Z)-enamide such as 6 was achieved (Scheme 1). To gain quick access to the desired substrates 5a-5i, we chose the direct condensation method due to its operational simplicity. As shown in Table 1, both isomers of 5 can be separated from the concentrated reaction mixture via flash column chromatography; in most cases, more of (Z)-enamide was obtained than the corresponding (E)-isomer. Although the moderate yields remain to be optimized, we found the present method is well suited for quick synthesis of both (Z)-5 and (E)-5 from inexpensive starting materials at laboratory scale. In addition, a diaryl enamide 5i was prepared in acceptable yield (entry 9, Table 1), which complements Pd-catalyzed amidation for this bulky substrate.[12b]
Scheme 1
Pd-catalyzed amidation for the synthesis of (Z)-enamide 6.[12]
Table 1
Preparation of (Z)- and (E)-5 via direct condensation of 7 with acetamide.[a]
With the synthesis of a set of enamides 5, we compared Rh-catalyzed asymmetric hydrogenation of (Z)-5a and (E)-5a with four widely used chiral ligands, including TangPhos (L1),[13a] DuanPhos (L2),[13b] Et-DuPhos (L3),[13c] and Binapine (L4).[13d] Notably, under the same reaction condition each ligand showed a striking difference in enantio-differentiating ability toward the two isomers (Table 2). For (Z)-5a, excellent ee’s were obtained by the use of all ligands except L4, with TangPhos giving the best result. Change of solvent had little effect on enantioselectivity. In contrast, much lower ee’s were observed for (E)-configured 5a in EtOAc, albeit with the same sense of product chirality as from (Z)-5a. Change of solvent gave no improvement of enantioselectivity. Therefore, unlike asymmetric hydrogenation of isomeric mixture of β-substituted α-aryl enamides 2,[3a,c,d,e,g] the configuration of double bond in 5 has a dramatic influence on enantioselectivity.[14] To achieve excellent enantioselectivity with current ligands, (Z)-configured substrates need to be used.
Table 2
Rh-catalyzed asymmetric hydrogenation of (Z)-5a and (E)-5a with different ligands.[a]
We further tested other substrates (Z)-5b-5i with Rh/TangPhos catalytic system under the optimized condition. As shown in Table 3, all substrates gave excellent ee’s. Substitution pattern on the phenyl ring generally has no appreciable effect on enantioselectivity (entries 2–4). Even hindered enamides (Z)-5h and (Z)-5i were hydrogenated with excellent results (entries 8, 9). At reduced catalyst loading (TON = 1000), (Z)-5a was still converted to 8a with almost unchanged ee (entry 10). Hence current hydrogenation route is a practical way for the preparation of various amines in this category (Figure 2).[15] For example, deacylation of the chiral product 8a leads directly to (S)-Amphetamine 9, which is a useful stimulant with strong biological and physiological effects.[16] Further modification will result in Selegiline 10 for the treatment of Alzheimer’s disease.[17] Asymmetric hydrogenation of (Z)-5c will also provide a practical access to important chiral drugs such as Formoterol 11[18] and Tamsulosin 12.[19]
Figure 2
Chiral drugs bearing β-aryl isopropylamine fragment.
Table 3
Asymmetric hydrogenation of (Z)-5 with Rh/TangPhos catalytic system.[a]
In this communication, we showed that β-aryl isopropylamines, an important class of chiral compounds with valuable pharmaceutical applications, can be prepared via highly efficient asymmetric hydrogenation. Excellent enantioselecitivity was obtained for (Z)-enamides, which were easily prepared via acid-catalyzed condensation of β-aryl ketone with acetamide. Alternatively, these substrates can be synthesized via Pd-catalyed amidation that exhibits better preference for the formation of (Z)-configured substrates.[12] Expansion of this methodology to other structurally relevant enamides is currently in progress and will be reported in a due course.