Abstract:With the rapid development of lithium-ion (Li-ion) batteries, battery thermal management (BTMS) is increasingly essential for the temperature control of Li-ion batteries. The energy required to control temperature is coming into focus. In order to consume less energy to control temperature and improve temperature uniformity, the liquid-cooled plate (LCP) based on bionic flow channels evolved from the shape of leaf veins and tree roots is proposed. In this BLCP, different from the others BLCPs, it is divided into a reinforced heat exchange area located in the middle and back part of the plate and a normal area located in the front part of the plate. Firstly, 16 sets of orthogonal tests are conducted based on four parameters: the distance of the hexagon from the outlet (a), the distance from the inlet (b), the distance between two adjacent hexagons (c) and the size of the hexagon (d). Secondly, Optimization was investigated based on NSGA-II for two objectives: temperature and pressure drop. The simulation results are analyzed based on the optimized structural parameters (a = 30 mm, b = 8 mm, c = 50 mm and d = 90 mm). After Comparing the optimization results with the simulation results, the temperature and pressure drop errors were 0.56 percent and 3.8 percent, respectively. The effects of flow rate and thickness of the fluid domain on temperature and pressure drop are next discussed separately. Finally, after comparing the optimized bionic liquid cooling plate (BLCP) with the conventional liquid cooling plate (CLCP) based on temperature pressure drop, velocity, and synergy angle, conclusions are made at the same inlet width, height, flow rate, and velocity (V = 0.2 m/s). This leads to the criterion of energy loss becoming only the pressure drop. The BLCP for pressure drop is 14.2 percent lower than the CLCP, which means less energy loss. The maximum temperature of the BLCP is 0.7 °C lower than that of the CLCP. Furthermore, the former has a better ability to suppress the rate of temperature rise and better temperature uniformity. In addition, this proposed new structure and research methods can be applied to the subsequent study of LCP.

Experimental investigation of roll bond liquid cooling plates for server chip heat dissipation

An Experimental Study of Microchannel and Micro-Pin-Fin Based On-Chip Cooling Systems with Silicon-to-Silicon Direct Bonding.

The optimization of roll-bond cold plate based on Taguchi-grey theory for server chips thermal management

Research progress of the liquid cold plate cooling technology for server electronic chips: A review

Experimental study on the thermal performance of a liquid-cooled heat sink integrating heat pipes for dual CPU servers

Experimental Study on the Thermal Performance of Flat Loop Heat Pipe Applied in Data Center Cooling

Study on heat transfer performance of cold plate with grid channel

Experimental study on the immersion liquid cooling performance of high-power data center servers

Design and performance research of integrated indirect liquid cooling system for rack server

Thermal study of the natural air cooling using roll bond flat heat pipe as plate fin under multi-heat source condition

A liquid-cooled plate based on bionic flow channels evolved from the shape of leaf veins and tree roots

Cold plate performance enhancement based on parametric modeling of multiple structures

A new stepped-channel liquid cooling plate thermal management system combined with composite phase change materials

Investigations on performance of single-phase immersion cooling system

Experimental Research and Energy Effectiveness Analysis on Chip-Level Two-Stage Loop Thermosyphon System for Data Centre Free Cooling

Effect of Direct Liquid Cooling Technology With Flow Guide Integration on Avionics Devices Thermal and Electrical Performance

Performance Analysis and Structural Optimization of a Finned Liquid-Cooling Radiator for Chip Heat Dissipation

Study on the design and application of liquid-cooling plate for vehicle integrated domain controller based on planar DNA-type flow channel

Experimental and numerical study on two-phase minichannel cold plate for high-power device

Server performance optimization for single-phase immersion cooling data center

Design of Practical Liquid Metal Cooling Device for Heat Dissipation of High Performance Cpus