Abstract:Dyes are one of the common contaminants in industrial wastewater. Adsorption is the most widely method which used to treat dye-contaminated water due to their easy use, cost-effectiveness, and their efficiency was high. The aim of this study is the investigating of the utilization of the activated carbon which prepared from Raphanus seeds solid residual (ACRS) as a low cost adsorbent for removing of cationic Methylene Blue dye (MB)from wastewater. measuring the surface area using BET methods and SEM. The FT‒IR and XRD was measured. Different variables (e.g.: initial concentration of the dye, pH, contact time, and dosage) have been studied. Process has been systematically investigated experimentally at (25 ± 1 °C). The % removal of MB reached 99.4% after 90-min MB adsorption (40 mg/L) was observed within 5 min of contact time for the Raphanus seeds solid residual (ACRS) dosage of 4 g/L. MB initial concentration (10 ppm) Raphanus seeds solid residual (ACRS) effectively adsorbed MB (> 99%) over a widely range of pH (from pH 2 to pH 8). However, a swift decline in removal was observed when the pH was set at 7. The results of the adsorption kinetics analysis indicate a strong correlation with the pseudo-second-order model, as evidenced by the high regression coefficients. However, the adsorption capacity diminished with a rise in temperature. Thermodynamic calculations of (MB) onto Raphanus seeds solid residual (ACRS) is an exothermic reaction. The results have been indicated that the effectiveness of MB removal by activated carbon prepared from Raphanus seeds solid residual is favorable under neutral conditions, Raphanus seeds solid residual (ACRS) can be considered an efficient, environmentally friendly, readily available, and economical adsorbent that could treat industrial wastewater contaminated with cationic textile dyes. The objective of the experiments was to investigate the impact of various factors on the response of a process or formulation. To accomplish this goal, response surface methodology (RSM) has employed as a statistical model. RSM is an efficient and effective method for optimizing processes through the use of a quadratic polynomial model. The utilization of RSM allows for a reduction in the number of experiments needed, thus minimizing the associated costs of extensive analysis. This method has been done using Box-Behnken Design (BBD) to optimize % removal of MB. The optimal conditions as obtained from the RSM is pH 7,contact time 120 min, initial concentration 10 ppm, ACRS dosage 1 g, adsorption temperature 45 °C.

Evaluation of biosorbent properties of Teucrium polium seeds in Rhodamine B removal; isotherm, kinetic, thermodynamic studies

Peanut shell biochar for Rhodamine B removal: Efficiency, desorption, and reusability

Assessment of biomass of moss Thuidium cymbifolium Dozy & Molk. for removal of Eriochrome Black T and Auramine-O dyes from aqueous solutions: Kinetics, Isotherms, Thermodynamics, and Microtoxicity studies

Utilization of peanut shell: investigating the adsorption mechanism and optimization of red 195 and reactive black-5

Investigation of the removal kinetics, thermodynamics and adsorption mechanism of anionic textile dye, Remazol Red RB, with powder pumice, a sustainable adsorbent from waste water

Microbial cells immobilized on natural biomatrix as a new potential ecofriendly biosorbent for the biotreatment of reactive dye contamination

Biosorption of Acid Black 172 and Congo Red from aqueous solution by nonviable Penicillium YW 01: kinetic study, equilibrium isotherm and artificial neural network modeling.

Adsorption of rhodamine-B by polypyrrole Sn (IV) tungstophosphate nanocomposite cation exchanger: Kinetic-cum-thermodynamic investigations

Removal of textile dye Bemacid Red from water using Casuarina equisetifolia needles: kinetic and thermodynamic modeling

Biosorption of the metal-complex dye Acid Black 172 by live and heat-treated biomass of Pseudomonas sp. strain DY1: kinetics and sorption mechanisms.

Experimental Study on Evaluation of Pumpkin Waste in Removal of Textile Dyes: Preparation, Characterization, Adsorption, and Desorption

Biosorption of Reactive Blue 13 and Pentachlorophenol from Dye Wastewater Using Treated Pseudomonas sp. Bacteria

Isothermal and kinetic investigation of sorption efficacy of titania and bentonite nanocomposite for brilliant green dye removal for wastewater treatment

Adsorption of cationic dye onto Raphanus seeds: optimization, adsorption kinetics, thermodynamic studies

Polymeric Adsorbent for the Effective Removal of Toxic Dyes from Aqueous Solutions: Equilibrium, Kinetic, and Thermodynamic Modeling

Potential of Titanium Dioxide to Remove Bromothymol Blue (BTB) in Aqueous Solution by Batch Mode Adsorption–Kinetic, Isotherm and Thermodynamic Studies

Kinetic and thermodynamic analysis of alizarin Red S biosorption by Alhagi maurorum: a sustainable approach for water treatment

Kinetics of the Removal of Polybrominated Diphenyl Ethers from Aqueous Solutions by Using pressure steamâ€“washed Black Tea

Separation of toxic rhodamine B from aqueous solution using an efficient low-cost material, Azolla pinnata, by adsorption method

Zwitterionic Polymer Brushes Coated with Mesoporous Silica Nanoparticles as Efficient Adsorbents for Dye Removal from Aqueous Solutions

Removal of Rhodamine B from aqueous solution by stalk corn activated carbon: adsorption and kinetic study