Abstract:Three-dimensional deformation is an important input to explore seismic mechanisms and geodynamics. The GNSS and InSAR technologies are commonly used to obtain the co-seismic three-dimensional deformation field. This paper focused on the effect of calculation accuracy caused by the deformation correlation between the reference point and the points involved in the solution, to build a high-accuracy three-dimensional deformation field for a detailed geological explanation. Based on the variance component estimation (VCE) method, the InSAR LOS, azimuthal deformation, and the GNSS horizontal and vertical deformation were integrated to solve the three-dimensional displacement of the study area in combination with the elasticity theory. The accuracy of the three-dimensional co-seismic deformation field of the 2021 Maduo MS7.4 earthquake obtained by the method proposed in this paper, was compared with that obtained from the only InSAR measurements obtained using a multi-satellite and multi-technology approach. The results showed the difference in root-mean-square errors (RMSE) of the integration and GNSS displacement was 0.98 cm, 5.64 cm, and 1.37 cm in the east-west, north-south and vertical direction respectively, which was better than the RMSE of the method using only InSAR and GNSS displacement, which was 5.2 cm and 12.2 cm in the east-west, north-south, and no vertical direction. With the geological field survey and aftershocks relocation, the results showed good agreement with the strike and the position of the surface rupture. The maximum slip displacement was about 4 m, which was consistent with the result of the empirical statistical formula. It was firstly found that the pre-existing fault controlled the vertical deformation on the south side of the west end of the main surface rupture caused by the Maduo MS7.4 earthquake, which provided the direct evidence for the theoretical hypothesis that large earthquakes could not only produce surface rupture on seismogenic faults, but also trigger pre-existing faults or new faults to produce surface rupture or weak deformation in areas far from seismogenic faults. An adaptive method was proposed in GNSS and InSAR integration, which could take into account the correlation distance and the efficiency of homogeneous point selection. Meanwhile, deformation information of the decoherent region could be recovered without interpolation of the GNSS displacement. This series of findings formed an essential supplement to the field surface rupture survey and provided a novel idea for the combination of the various spatial measurement technologies to improve the seismic deformation monitoring.

The Induced Seismicity Effect in Morocco Caused by a Reduced Aquifers Volume according to Stacking-InSAR Method and Gravimetric Data

The 2023 Mw 6.8 Morocco Earthquake: A Lower Crust Event Triggered by Mantle Upwelling?

The 8 September 2023, MW 6.8, Morocco Earthquake: A Deep Transpressive Faulting Along the Active High Atlas Mountain Belt

Geomagnetic and Ionospheric Effects of Two Consecutive Strong Earthquakes in Morocco on September 8, 2023

Source parameters of the May 28, 2016, Mihoub earthquake (Mw 5.4, Algeria) deduced from Bayesian modelling of Sentinel-1 SAR data

Directivity analysis and source parameter estimation: insights from the 2014 Arzew earthquake, Mw3.9, northwestern Algeria

Present-day kinematics of the NW Moroccan Atlantic Margin from GNSS data: WSW extrusion at the western end of the High Atlas

Constraints on the 2013 Saravan intraslab earthquake using permanent GNSS, InSAR and seismic data

Fault Geometry, Slip Distribution, and Potential Triggering of the 2022 Mw 6.2 Deadly Afghanistan Earthquake Revealed from Geodetic and Weather Data

Source mechanism of the 2023 Ms 5.5 earthquake in Subei, Gansu Province revealed by relocated aftershocks and InSAR: complement to the 'shallow slip deficit' of the eastern boundary of the Altyn Tagh fault

Estimation of Co-Seismic Surface Deformation Induced by 24 September 2019 Mirpur, Pakistan Earthquake along an Active Blind Fault Using Sentinel-1 TOPS Interferometry

Investigation relationship between TEC anomalies and space weather conditions: Morocco earthquake example

Analyzing recent deformation in Wadi Hagul, Eastern Desert, Egypt, via advanced remote sensing and geodetic data processing

Barrier-Induced Rupture Front Disturbances during the 2023 Morocco Earthquake

Sunda-arc seismicity: continuing increase of high-magnitude earthquakes since 2004

InSAR Analysis of Partially Coherent Targets in a Subsidence Deformation: A Case Study of Maceió

Source Parameter Inversion and Century-Scale Stress Triggering Analysis of the 2021 Maduo MW7.4 Earthquake Using GNSS and InSAR Displacement Fields

Geological and hydrogeological drivers of seismic deformation in L'Aquila, Italy: insights from InSAR analysis

The Crustal Dynamics and Its Geological Explanation of the Three-Dimensional Co-Seismic Deformation Field for the 2021 Maduo MS7.4 Earthquake Based on GNSS and InSAR

Subsidence in the Kathmandu Basin, before and after the 2015 Mw 7.8 Gorkha Earthquake, Nepal Revealed from Small Baseline Subset-DInSAR Analysis

Discriminating the Multi-Frequency Microwave Brightness Temperature Anomalies Relating to 2017 Mw 7.3 Sarpol Zahab (Iran-Iraq Border) Earthquake