Abstract:The development of fast-response, high sensitivity and selectivity gas sensors for monitoring of organophosphorus is essential, where two dimensional graphene-based materials possessing exceptionsal carrier mobility are considered as promising candidates for room-temperature organophosphorus detection. However, it is challenging to fabrication of graphene-based gas sensors for detection of organophosphorus with excellent sensing performances. Herein, we develope a self-redox strategy to synthesize polypyrrole decorated-reduced graphene oxide hybrids (PPy-rGO) by redox reactions between pyrrole and GO during hydrothermal treatment process. This self-redox strategy results in the formation of perfact interfical strucutre between PPy and rGO through the 7C-7C interactions without the impurity from the conventional oxidation/reducing agents. Most importantly, such PPy-rGO hybrids can be used as novel sensing materials for detection of dimethyl methylphosphonate (DMMP) at room temperature. Specially, the response of PPy-rGO-based sensor towards 100 ppm DMMP can reach 12.9 %, which is 3-fold higher than that pristine rGO-based sensor. Meanwhile, PPy-rGO-based sensor exhibits short response time/recovery time (43 s/75 s), low detection limit (5 ppm), excellent repeatability, and high selectivity. By combination of FT-IR and N2 sorption isotherms, the enhanced DMMP sensing performances of PPyrGO hybrids are concluded as following two aspects. Firstly, the formation of hydrogen bonds between PPyrGO hybrids and DMMP molecules regulates the adsorption/desorption of DMMP. Secondly, increasing BET surface area by introduction of PPy into rGO matrix is beneficial to DMMP diffusion among the sensing materials. Our work would offer a new strategy for rational development of graphene-based materials for detection of organophosphorus at room temperature.

Pt, Pd and Au decorated reduced graphene oxide: Sensing properties for phenol gas detection at room temperature

High Sensitive Reduced Graphene Oxide-Based Room Temperature Ionic Liquid Electrochemical Gas Sensor with Carbon-Gold Nanocomposites Amplification

Response of rGO and Pd-Decorated rGO to Carbon Monoxide Gas

Reduced graphene oxide functionalized zinc octaethyl porphyrin (rGO/Zn OEP) for selective detection of carbon monoxide in chemiresistive modality

Amplified sensing of nitrogen dioxide with a phosphate-doped reduced graphene oxide powder

Reduced graphene oxide-based broad band photodetector and temperature sensor: effect of gas adsorption on optoelectrical properties

Poly(N-methyl pyrrole) decorated rGO nanocomposite: A novel ultrasensitive and selective carbon monoxide sensor

Sensing of volatile pollutants on reduced graphene oxide-polypyrrole composite: DFT investigation

Fabrication of gas sensor device using poly (3, 4-ethylenedioxythiophene)-poly (styrenesulfonate)-doped reduced graphene oxide organic thin films for detection of ammonia gas at room temperature

Porous reduced graphene oxide for ultrasensitive detection of nitrogen dioxide

Highly sensitive, selective, repeatable and flexible chemiresistive NO2 sensor based on reduced graphene oxide/free based porphyrin composite

Biphenyl-rGO composite room temperature gas sensor for enhanced amine sensing

Highly responsive and selective ppb-level NO<sub>2</sub> gas sensor based on porous Pd-functionalized CuO/rGO at room temperature

Ultrasensitive Chemical Sensing Through Facile Tuning Defects and Functional Groups in Reduced Graphene Oxide.

Conductometric Gas Sensor Based on MoO3 Nanoribbon Modified with rGO Nanosheets for Ethylenediamine Detection at Room Temperature

Formadelyde-sensing Properties of Reduced Graphene Oxide by Layer-by-layer Self-Assemble Method

Hydrogen Bonds-Induced Room-Temperature Detection of DMMP Based on Polypyrrole-Reduced Graphene Oxide Hybrids

Reduced Graphene Oxide for Room Temperature Ammonia (NH3) Gas Sensor

Isolated Cu-N5 sites engineered polypyrrole-reduced graphene oxide hybrids for enhancing room-temperature DMMP sensing

A Reduced Graphene Oxide Based Biosensor for High-Sensitive Detection of Phenols in Water Samples

Towards an Improved Electrocatalytic Material for Detection of Polyphenols Based on Transition Metal Phosphides Anchored on Reduced Graphene Oxide