Abstract:Background and objectives: Laser surgical procedures involving photocoagulation of soft tissue have relied on subjective visual endpoints. The thermal damage to the denatured tissue in these procedures is highly dependent on the tissue temperatures achieved during laser irradiation. Therefore, a system capable of real time temperature monitoring and closed loop feedback was used to provide temperature controlled photocoagulation (TCPC). Study design/materials and methods: The TCPC system consisted of a 1.32 microns Nd:YAG laser, an infrared thermometer, and a microprocessor for data acquisition and feedback control. A porcine skin model was used. Tissue welds were completed to evaluate the photocoagulation effects at different predetermined temperatures. A quantitative measurement of tissue photocoagulation was obtained by tensile strength measurements of the laser repairs. Histology of the irradiated tissue was used to determine the extent of thermal injury associated with different photocoagulation temperatures. Results: The TCPC system was capable of maintaining a relatively constant temperatures (+/- 4 degrees C) during laser irradiation. The tensile strengths of acute repairs increased with temperature over the range studied (65-95 degrees C). Tensile measurements made after several days of healing showed that higher temperature (95 degrees C) welds had lower strengths than repairs completed at lower (65 degrees C or 75 degrees C) temperatures and were significantly lower at 3 days. Acute histology showed that the amount thermal damage was strongly dependent on the tissue temperature and increased both in tissue depth and lateral to the repair with temperature. The histologic results suggest that the increase in the acute repair tensile strength as the weld temperature increased was due to an increase in the depth of tissue photocoagulation. The increase in the lateral tissue injury measured histologically for higher temperature welds likely resulted in the decreased chronic tensile strengths, as a healing response to excessive thermal damage. Conclusion: Tissue temperatures can be controlled during laser photocoagulation of skin. The degree of acute and chronic tissue damage is highly dependent on the temperature during welding. By controlling the tissue temperature during laser procedures, the surgical outcome can be more reliably predicted and reproduced, as compared to the conventional open loop methods. In addition, the use of a TCPC system should significantly reduce the learning curve for photothermal surgical procedures.

Real‐time guidance of thermal and ultrashort pulsed laser ablation in hard tissue using inline coherent imaging

Dynamic Interface for Three-Dimensional Transient Laser Ablation Polymer Microchannels

Interventional Real-Time Optical Imaging Guidance for Complete Tumor Ablation

Fully-automatic laser welding and micro-sculpting with universal in situ inline coherent imaging

Interstitial Optical Monitoring of Focal Laser Ablation

Stereo vision-based tracking of soft tissue motion with application to online ablation control in laser microsurgery

Laser-Induced Focused Ultrasound for Cavitation Treatment: Toward High-Precision Invisible Sonic Scalpel

Ultrasound and Photoacoustic Imaging for the Guidance of Laser Ablation Procedures

Real-time Spectral Response Guided Smart Femtosecond Laser Bone Drilling

Towards phase-sensitive optical coherence tomography in smart laser osteotomy: temperature feedback

Multimodal feedback systems for smart laser osteotomy: Depth control and tissue differentiation

Ultrafast dynamics of hard tissue ablation using femtosecond-lasers

Preliminary Results of Laser Ablation during In Vivo Experiments: Comparison of Thermal Effects Obtained with Bare and Diffuser Tip Applicators

Micro laser ablation system integrated with image sensor for minimally invasive surgery

Temperature-controlled laser photocoagulation of soft tissue: in vivo evaluation using a tissue welding model

A Novel OCT Image-Guided Laser Automatic Ablation Method Based on Non-common Optical Path Structure

Thermal and Thermomechanical Phenomena During Ultrafast Laser Interaction With Tissue

Ablation-cooled material removal with ultrafast bursts of pulses

Automatic Laser Ablation Control Algorithm for an Novel Endoscopic Laser Ablation End Effector for Precision Neurosurgery

Precise Spatially Selective Photothermolysis Using Modulated Femtosecond Lasers and Real-time Multimodal Microscopy Monitoring

Optimization of processing parameters and conditioning for efficient bone tissue ablation by femtosecond laser