Abstract:This paper presents a variety of viewpoints from engineers within the power cable industry as to how current trends in the cable industry will influence future cable designs, particularly with polymeric insulation, lapped dielectrics, and improved diagnostic techniques. The use of high-temperature superconductors and designer polymers as well as the possible availability of conducting polymeric materials is also considered. The paper first reviews how the design of distribution cables has differed historically around the world, the major differences being allied to the systems. Designs largely have been divided into two main categories: those countries following U.K. and European practices, and those having adopted the U.S. system design. However, these differences, such as the use of three-phase cables in the U.K. as opposed to single-phase cables in the U.S., are not so obvious nowadays. Installation practices are becoming rather more standardized, such as the use of ducts, directional drilling, etc. The predominant primary insulation is cross-linked polyethylene (including tree-retardant XLPE), which is used all around the world. Some constructional differences such as the “dry” and “wet” designs persist. The paper then discusses cables from the mid–twentieth century projected into the twenty-first century. Highlighted are the opportunities that will present themselves in the twenty-first century: fluid-filled cables, XLPE cables, intelligent cables, and designer polymers that optimize performance and economic advantages of buried cables. It then focuses on economic trends, power generation trends, lower-cost underground systems, overhead line/underground cables, and materials and environmental trends including use of high-temperature conductors to up-rate overhead circuits. The trend will be toward greater security and utilization using on-line diagnostics, greater circuit diversity due to distributed generation and lower cost cable systems, and extensive use of polymeric materials having low environmental impact. A futuristic view of energy cables in the year 2050 is presented. Discussed are the elements of the “info-energy cable,” the advantages of the cable technology, and the advantages for the network configuration. A realistic view of tendencies in cable systems technology over the next decade is outlined. Also discussed is choice of cable for subsea power links: choice of cable design that exists for subsea power links, the merits of the various designs, installation of submarine cables, protection of submarine cables, new challenges in HVdc submarine cable systems, and future developments. The manufacture and installation of long continuous lengths of subsea power cable is discussed with reference to some key installations. The paper goes on to examine the Kontex HVdc link between Denmark and Germany. The cable link has been in commercial operation since 1996, and with a total length of 172 km and a transmission capacity of 600 MW at 400 kV is still unique worldwide. Details of the link together with its installation and commissioning are explained. Gas-insulated transmission lines are also discussed together with whether they are ready for real-world transmission systems.

Power Delivery of the Future

Improved Power System of the Future

Survey on Fault-Tolerant Techniques for Power Electronic Converters

Editorial: Special Issue on High-Frequency-Link Power-Conversion Systems, 2014

High-Frequency High-Density Bidirectional EV Charger

Data Center Power Supply Systems: from Grid Edge to Point-of-Load

Power Electronics - Key Technology for Renewable Energy Systems - Status and Future

Power Electronics - the Key Technology for Renewable Energy System Integration

Guest Editorial Special Section Advances in Research and Applications of Power Electronics in T&D Systems

Future Distribution Networks: A Review

Editorial: Advanced Technologies for Modeling, Optimization and Control of the Future Distribution Grid

Power Electronics-the Enabling Technology for Renewable Energy Integration

The Electric Power Grid: Today and Tomorrow

On a Future for Power Electronics

Challenges of Future High Power Wireless Power Transfer for Light-Duty Electric Vehicles----technology and Risk Management

Extreme Fast Charging Technology—Prospects to Enhance Sustainable Electric Transportation

Implementation of Resistive Type Superconducting Fault Current Limiters in Electrical Grids: Performance Analysis and Measuring of Optimal Locations

A survey on fault current limiters: Development and technical aspects

Power Cables in the Twenty-First Century

Evolving and Emerging Applications of Power Electronics in Systems

A Novel Fast Energy Storage Fault Current Limiter Topology for High-Voltage Direct Current Transmission System