Abstract:We report on the construction and upgrade of a Lawrence Berkeley National Laboratory Cosmic Muons Detector. We modify the electronics and mechanics to achieve a highly efficient gamma-ray and cosmic-ray detector. Each detector module uses a one-inch-thick scintillator, attached to a photomultiplier tube (PMT) and mounted on a solid aluminum frame. The detector uses scintillation to transform passing radiation into detectable photons that are guided toward a photocathode surface of the PMT, triggering the release of photoelectrons that are then amplified to yield measurable electronic signals. The modules were connected to an electronics section that compared the signals from the two PMTs and logically determined if they were coincidence events. A data-collection device was added for faster and prolonged count rates. A cobalt-60, which produced two gamma rays and a beta particle has been used as a calibration source. To investigate the isotropic behavior of radiation, two detection modules were adjusted to different angles of rotation with respect to each other, and the coincidence counts were measured. The coincidence counts from the modules set at various angles were consistent throughout the angular spectrum, and only lead shielding visibly reduced the number of counts from the radioactive source. The inverse-square-law behavior of radiation has also been considered. The results were such that the number of counts decreased as a function of increasing distance from the source. Furthermore, positioning the detector to point toward the sky in different orientations, we measured cosmic ray muon flux as the angle from the vertical was decreased. In doing so, we scanned different patches of the atmosphere. For the optimum operation during the detection phase, we plateaued both PMTs to single out their best operating gain voltage while eliminating false background noise signals.

Development of Silicon Strip Detectors for a Medium Energy Gamma-ray Telescope

From 3D to 5D tracking: SMX ASIC-based Double-Sided Micro-Strip detectors for comprehensive space, time, and energy measurements

Characterisation of silicon microstrip detectors for the ATLAS Phase-II Upgrade with a micro-focused X-ray beam

Development of a compact scintillator-based gamma-ray neutron detector for terrestrial and space applications

High-Rate Capable Floating Strip Micromegas

Pixelized Gas Micro-well Detectors for Advanced Gamma-ray Telescopes

The CMS Silicon Strip Tracker - Overview and Status

Towards GaAs Thin-Film Tracking Detectors

Agata detector technology: recent progress and future developments

A Comparison of Micromegas with x/y Strip Charge Readouts for Directional Recoil Detection

A triple-GEM Detector with pixel readout for high-rate beam tracking in COMPASS

Development of Si Multi-Strip Detector

A GEM readout with radial zigzag strips and linear charge-sharing response

The Silicon Microstrip Tracker for CMS

Development of Transition-Edge Sensor X-ray Microcalorimeter Linear Array for Compton Scattering and Energy Dispersive Diffraction Imaging

Development of a 3” LaBr3 SiPM-Based Detection Module for High Resolution Gamma Ray Spectroscopy and Imaging

Analysis of Gamma Rays and Cosmic Muons with a Single Detector

Development of a Triple-GEM detector with strip readout and GEMINI chip for X rays and neutron imaging

Large-scale detector testing for the GAPS Si(Li) Tracker

Characterisation of resistive MPGDs with 2D readout

Exploring Large-Volume GAGG Scintillators for use in MeV Gamma-Ray Astrophysics