Abstract:LISA (Laser Interferometer Space Antenna) is a proposed mission which will use coherent laser beams exchanged between three remote spacecraft to detect and study low-frequency cosmic gravitational radiation. Modeling each spacecraft as moving almost inertially, rigidly carrying a laser, beam splitters and photodetectors, we previously showed how the measured time series of Doppler shifts of the six one-way laser beams between spacecraft pairs could be combined, with suitable time delays, to cancel exactly the otherwise overwhelming phase noise of the lasers. Three of the combinations synthesized data that could in principle be obtained if the spacecraft separations were very precisely equal, as in Michelson interferometry; seven other combinations offered possible design advantages and useful redundancy. Here we extend those results by presenting time-delay equations for Doppler data from the actual drag-free configuration envisaged for the LISA mission. Each spacecraft will carry two proof-masses, shielded within two non-inertial optical benches carrying lasers and photodetectors. In this full drag-free configuration there are now twelve Doppler data streams, six measured with beams between the three vertex spacecraft and two with beams between each of the optical bench pairs on the three spacecraft. We show that generalizations of our previous linear data combinations, now using these twelve one-way Doppler measurements, can cancel the noises of all six lasers and also remove Doppler shifts due to the non-inertial motions of the six optical benches. It is noteworthy that adjacent optical benches need not be rigidly connected and that no phase locking of their lasers is required. From the latest LISA estimates for power spectra of remaining Doppler noises (very-low-level proof-mass “acceleration” noise, photodetector shot noise, and beam pointing noise) we compute the sensitivities of the generalized data combinations X and P. In the Appendix we give defining equations and sensitivity results for two additional data combinations, denoted E and U. Like X and P, these combinations only require data from four one-way laser links between the LISA spacecraft. LISA can achieve the desired gravitational wave strain performance of ∼10-23 with any of these combinations.

LISA data analysis: Source identification and subtraction

Global Analysis of the Gravitational Wave Signal from Galactic Binaries

Global Analysis of LISA Data with Galactic Binaries and Massive Black Hole Binaries

An Overview of LISA Data Analysis Algorithms

Extraction of gravitational wave signals in realistic LISA data

Time-delay analysis of LISA gravitational wave data: Elimination of spacecraft motion effects

Identifying Disappearance of a White Dwarf Binary with LISA

Resolving Galactic binaries in LISA data using particle swarm optimization and cross-validation

Fast resolving Galactic binaries in LISA data and its ability to study the Milky Way

Post-processing subtraction of tilt-to-length noise in LISA in the presence of gravitational wave signals

The LISA interferometer: impact of stray light on the phase of the heterodyne signal

On the LISA science performance in observations of short-lived signals from massive black hole binary coalescences

LISA parameter estimation and source localization with higher harmonics of the ringdown

Prototype global analysis of LISA data with multiple source types

Identifying LISA verification binaries amongst the Galactic population of double white dwarfs

Introduction to the Analysis of Low-Frequency Gravitational Wave Data

Detectability of Modulated X-Rays from LISA’s Supermassive Black Hole Mergers

Pointing LISA-like gravitational wave detectors

LISA Galactic binaries with astrometry from Gaia DR3

The LISA Data Challenge Radler Analysis and Time-dependent Ultra-compact Binary Catalogues

A test for LISA foreground Gaussianity and stationarity. I. Galactic white-dwarf binaries