Friction and Wear Properties of CoCrFeNiMnSnx High Entropy Alloy Coatings Prepared via Laser Cladding
Jie Sun,Sichao Dai,Dabin Zhang,Wudong Si,Benchi Jiang,Da Shu,Lulu Wu,Chao Zhang,Meisong Zhang,Xinyan Xiong
DOI: https://doi.org/10.3390/met12071230
IF: 2.695
2022-07-22
Metals
Abstract:Due to its unique single-phase multivariate alloy characteristics and good low-temperature mechanical properties, CoCrFeNiMn high entropy alloy (HEA) has attracted the interest of many researchers in recent years. In this paper, to improve the wear resistance of Q235 alloy steel surface, CoCrFeNiMnSnx HEA coatings were prepared on the surface of Q235 steel via laser cladding. X-ray diffractometry, optical microscopy, scanning electron microscopy (SEM), and energy dispersive spectrometry were used to determine the microstructure and chemical composition. The research findings revealed that the CoCrFeNiMn HEA coatings were formed from a single FCC phase. As the Sn content in the coating increased, a new MnNi2Sn phase formed. Microhardness and friction and wear results showed that when the mole content of Sn was 0.2, the hardness of the CoCrFeNiMn HEA coating was increased by approximately 45%, the friction coefficient decreased by 0.168, and the wear loss decreased by 16.6%. Three-dimensional noncontact morphology and SEM results revealed that the wear mechanisms of CoCrFeNiMn HEA coatings were abrasive wear, delamination wear and a small amount of oxidative wear under dry friction conditions, whereas the friction mechanisms of CoCrFeNiMnSn0.2 HEA coatings were primarily abrasive wear and oxidative wear.
materials science, multidisciplinary,metallurgy & metallurgical engineering