Abstract:Sludge conditioning by the Fenton process can effectively reduce sludge water content. The Fenton process has ideal dewaterability at different initial pH levels. However, the difference in the initial pH levels can lead to variations in conditioner dosage, resulting in different environmental impacts and economic pressures. This study provides insights into the role of the life cycle linked response surface methodology (LC-RSM) framework in revealing optimal solutions with both environmental and economic performance in different combinations of conditioners. Response surface methodology (RSM) was used to construct a model of sludge dewatering by the Fenton process, and life cycle assessment and life cycle cost were used to quantify the environmental and economic performance of all conditioning solutions in the model. The LC-RSM optimization solution was 6%–68% and 15%–70% lower than the RSM recommended solution in terms of environmental impacts and economic costs, respectively. For specific impact categories, such as global warming potential, the LC-RSM optimization solution was 19%–56% lower than the RSM recommended solution. In addition, the total environmental impact of the different conditioner combinations ranged between 4.1 and 7.8 Pt and 3.2–6.7 Pt at 53% and 58% of the sludge target water content, respectively. Surprisingly, the environmental impact of the solution with superior dewatering performance (53%) was lower than that of the solution with poor dewatering performance (58%) in many cases. The above results show that the LC-RSM optimization solution has better environmental and economic performance compared to RSM. In addition, the environmental impacts and economic costs of different solutions with the same water content target vary widely, which may lead to comparing sludge conditioning procedures with different targets in an unfair environment. Therefore, a unified platform for comparison is needed, and LC-RSM can provide support. This study can assist decision-makers in identifying the best solution for both environmental and economic performance in a multivariate system and stimulate further discussion on how to compare different processes on a more uniform platform.

Sludge deep dewatering by liquefied dimethyl ether: selection of operating conditions based on response surface methodology

Measurement and Modelling of Moisture Distribution and Water Binding Energy of Dredged Sludge

Optimizing and Understanding the Pressurized Vertical Electro-Osmotic Dewatering of Activated Sludge

Highly effective in-depth dewatering of excess sludge using methanol

Response surface optimization of sludge dewatering process: synergistic enhancement by ultrasonic, chitosan and sludge-based biochar

Deep dewatering of sewage sludge and simultaneous preparation of derived fuel via carbonaceous skeleton-aided thermal hydrolysis

Feasibility of sludge deep dewaterability improvement for incineration disposal by combined conditioning of freeze-thaw and sawdust

Experimental Study on Thermal Hydrolysis and Dewatering Characteristics of Mechanically Dewatered Sewage Sludge

Process control for improving dewatering performance of sewage sludge based on carbonaceous skeleton-assisted thermal hydrolysis

Deep-dewatering of Sewage Sludge Using Double Dielectric Barrier Discharge (DDBD) Plasma Technology.

Multiscale experimental insights into vacuum drying of sludge for enhanced energy efficiency and emission control

Steam explosion coupled with freeze-thaw cycles: An efficient and environmentally friendly method for deep dewatering of sewage sludge

Enhanced technology based for sewage sludge deep dewatering: A critical review

Revealing the best solution simultaneously for environmental and economic performance using response surface methodology under the perspective of life cycle: A case study of sludge dewatering by the Fenton process

Coupling Mechanism and Parameter Optimization of Sewage Sludge Dewatering Jointly Assisted by Electric Field and Mechanical Pressure

Sludge low-temperature drying with mainly non-phase change in mere seconds based on particle high-speed self-rotation in cyclone

Improvement of Sludge Dewatering Performance by Persulfate Advanced Oxidation Combined with Ldh: Synergistic Effect of Free Radical and Non-Free Radical and Reuse of Deep-Dewatered Sludge Cake

Enhancement of conductive drying of sewage sludge with mechanical compression: Drying kinetics, and interfacial heat transfer behavior

Sludge Drying Using Flue Gas and Its Role in Haze Source Control

Insight into sludge dewatering by periodate driven directly with Fe(Ⅱ): Extracellular polymeric substances solubilization and mineralization

Optimizing sludge dewatering with an alternate pressure and electric field