Pollutant Emissions and Heavy Metal Migration in Co-Combustion of Sewage Sludge and Coal

Liu,Yue,Ma
DOI: https://doi.org/10.3390/en17112457
IF: 3.2
2024-05-22
Energies
Abstract:The treatment of sewage sludge has become a global concern. Large amounts of sewage sludge can be disposed of by burning coal-mixed sludge. Thermogravimetric analysis and lab-scale combustion experiments in a drop tube furnace were utilized to study the combustion characteristics, pollutant emissions, and heavy metal migration during the co-combustion of coal and sewage sludge. The results showed that the blended fuels with a sewage sludge content less than 10 weight percent exhibited coal-like combustion characteristics. Additionally, the additional sewage sludge favored the ignition performance of blended fuels. When sewage sludge was added, the SO2 emissions rose to 76 mg/Nm3 under the 10% sludge condition—nearly three times higher than that of coal alone. While NOx emissions stayed mostly unchanged, HCl and HF emissions were very low. Meanwhile, Cr, Cu, and Ni migrated to the bottom ash, and their concentrations were all reduced with an increase in sewage sludge. Pb, Cd, Cr, Cu, Ni, and Hg migrated to the flue gas, mostly in the form of gaseous components. The results provide crucial information in the co-combustion of sewage sludge and coal, with implications in the development and improvement of large-scale, harmless, and resource-recovering techniques for waste sludge.
energy & fuels
What problem does this paper attempt to address?
### The Problem Addressed by This Paper This paper aims to explore the behavior of pollutant emissions and heavy metal migration during the co-combustion of sludge and coal at different ratios (0% to 10%). Specifically, the study focuses on the following aspects: 1. **Combustion Characteristics**: Investigate the combustion characteristics of mixed fuels with different ratios of sludge and coal, including ignition temperature, combustion rate, and other parameters, through thermogravimetric analysis (TG) and laboratory-scale drop tube furnace experiments. 2. **Gaseous Pollutant Emissions**: Analyze the emissions of gaseous pollutants such as sulfur dioxide (SO₂), nitrogen oxides (NOₓ), hydrogen chloride (HCl), and hydrogen fluoride (HF) during the co-combustion process, and explore the impact of sludge ratio on these pollutant emissions. 3. **Heavy Metal Migration**: Study the migration behavior of heavy metals (such as chromium, copper, mercury, nickel, cadmium, lead, etc.) during the co-combustion process, including their distribution in bottom ash, fly ash, and flue gas, and further analyze their forms through theoretical simulation. ### Research Background With the increasing amount of sludge generated during urban sewage treatment, effectively handling this sludge has become a global challenge. Traditional treatment methods such as landfilling, agricultural use, and composting have many limitations, thus thermal treatment technologies (such as combustion, gasification, and pyrolysis) have gradually gained attention. Among them, the co-combustion technology of sludge and coal is favored for its ability to recover energy. However, the potential issues of pollutant emissions and heavy metal migration during the co-combustion process need to be thoroughly studied to ensure the safety and environmental friendliness of this technology. ### Research Significance This study provides important fundamental data for the development of sludge and coal co-combustion technology, helps optimize the co-combustion process, reduces pollutant emissions, and improves energy utilization efficiency, thereby achieving harmless and resourceful treatment of sludge.