Design and Tests of the Silicon Sensors for the ZEUS Micro Vertex Detector

D. Dannheim,U. Koetz,C. Coldewey,E. Fretwurst,A. Garfagnini,R. Klanner,J. Martens,E. Koffeman,H. Tiecke,R. Carlin
DOI: https://doi.org/10.1016/S0168-9002%2803%2900618-1
2002-12-12
Abstract:To fully exploit the HERA-II upgrade,the ZEUS experiment has installed a Micro Vertex Detector (MVD) using n-type, single-sided, silicon micro-strip sensors with capacitive charge division. The sensors have a readout pitch of 120 micrometers, with five intermediate strips (20 micrometer strip pitch). The designs of the silicon sensors and of the test structures used to verify the technological parameters, are presented. Results on the electrical measurements are discussed. A total of 1123 sensors with three different geometries have been produced by Hamamatsu Photonics K.K. Irradiation tests with reactor neutrons and Co-60 photons have been performed for a small sample of sensors. The results on neutron irradiation (with a fluence of 1 x 10^{13} 1 MeV equivalent neutrons / cm^2) are well described by empirical formulae for bulk damage. The Co-60 photons (with doses up to 2.9 kGy) show the presence of generation currents in the SiO_2-Si interface, a large shift of the flatband voltage and a decrease of the hole mobility.
High Energy Physics - Experiment
What problem does this paper attempt to address?
The main problems that this paper attempts to solve are mainly focused on the construction of the quantum supersymmetric vector multiplet and its consistency in the non - Abelian supergauge theory. Specifically, the author explores the following key issues: 1. **Differences in super - propagator expressions**: The author points out that there are some inconsistencies in the expressions of super - propagators in the literature and attempts to correct these differences through strict derivations. In Markdown format, the super - propagator can be written as: \[ G(x, \theta, \bar{\theta})=\langle T[V(x, \theta, \bar{\theta}), V(0)]\rangle \] where \(V(x, \theta, \bar{\theta})\) is the superfield of the vector multiplet. 2. **Consistency conditions of the model**: The paper proves that the model is consistent only when the mass is positive. Specifically, for the case of mass \(m > 0\), the model can maintain internal self - consistency. 3. **Gauge structure and the introduction of ghost fields**: The author constructs the gauge structure through a pure deductive method and finds that in order to ensure the consistency of the model, scalar ghost superfields must be introduced. This is similar to the treatment in traditional gauge theories. For example, the introduction of the ghost field \(C\) and the anti - ghost field \(\bar{C}\) can be written as: \[ S_{\text{ghost}}=\int d^{4}x\left(\bar{C}\Box C+\ldots\right) \] 4. **Supersymmetric gauge invariance conditions**: The author discusses how to define supersymmetric gauge invariance conditions in a quantum framework. They propose a stronger condition: \[ [Q, T(x, \theta, \bar{\theta})]=i\partial_{\mu}T^{\mu}(x, \theta, \bar{\theta})+\ldots \] Here \(T(x, \theta, \bar{\theta})\) is a supersymmetric Wick polynomial. This condition is more stringent than the traditional one but more difficult to satisfy. 5. **Construction of the interaction Lagrangian**: The paper analyzes how to construct an interaction Lagrangian that is consistent with the path - integral quantization method. The author finds that the expressions of the interaction Lagrangian in the general literature cannot satisfy the above - mentioned supersymmetric gauge invariance conditions, so new expressions need to be sought. In summary, this paper mainly focuses on how to construct and verify the supersymmetric vector multiplet model in a strict quantum framework, especially the difficulties and challenges encountered in dealing with super - propagators, gauge structures, and interaction Lagrangians.