Abstract:Highlights • Effects of microstructure inhomogeneity on tensile deformation behavior of ZK60 Mg were clarified. • Tensile temperature and loading direction determined the slipping- or twinning-dominated deformation mode. • DRX was changed from continuous mode to discontinuous mode with increasing tensile temperature. • Welding zone showed superplastic behavior at tensile temperature > 300 °C due to the GBS effects. • The texture evolution was dependent on loading direction, tensile temperature and recrystallization mode. The tensile tests of the extruded ZK60 Mg containing a longitudinal weld seam were carried out at room and elevated temperatures, and the effects of induced microstructure inhomogeneity on tensile deformation behavior was clarified. The results show that the deformation mode, dynamic recrystallization (DRX), texture evolution and mechanical properties are strongly affected by the longitudinal weld seam, temperature, and loading direction. The room temperature (RT) deformation of welding zone is controlled by the dislocation slips with the association of some twins, while twinning plays significant roles in the accommodation of c -axis strain of the coarse grains on matrix zone. The deformation at RT stretched along extrusion direction (ED) and transverse direction (TD) are controlled by basal slip/twinning and basal slip/prismatic slip/twinning, respectively. During high temperature tension, the dislocation cross slip of pyramidal slip is activated, and grain boundary sliding occurred in welding zone, leading to the superplastic behavior. With the increase of tensile temperature, the predominant DRX mode is transformed from continuous DRX to discontinuous DRX. Moreover, the basal poles of the grains spread from TD towards ED with the decrease of maximum pole intensity when stretched along ED, while non-basal textures are transformed to 〈10–10〉 fiber texture when stretched along TD. The slip-dominated flow is seen during RT tension along ED, while twinning becomes predominant during RT tension along TD. The fine grain structure causes the superior RT tensile properties along ED of welding zone with ultimate tensile strength of 315 MPa and elongation to failure of 13.8%. With the increase of tensile temperature, the slipping-dominated deformation is transformed into twinning-dominated, causing the decrease of strength and increase of elongation.

Experimental study on tensile deformation behaviors under room and elevated temperatures induced by microstructure inhomogeneity of ZK60 Mg with a longitudinal weld

Weakened anisotropy of mechanical properties in rolled ZK60 magnesium alloy sheets with elevated deformation temperature

Unveiling the mechanical response and deformation mechanism of extruded Mg-2.5Nd-0.5Zn-0.5Zr alloy sheet under high-temperature tensile

A comprehensive analysis on microstructure evolution of Mg-5.65Zn-0.66Zr alloy during hot deformation

Tensile behavior at various temperatures of the Mg-Gd-Y-Zn-Zr alloys with different initial morphologies of LPSO phases prior to extrusion

Compressive Deformation of ZK60 Magnesium Alloy at Elevated Temperature

Deformation behaviors and the related high-temperature mechanical properties of Mg-11Gd-5Y-2Zn-0.7Zr via regulating extrusion temperatures

In-Situ Analysis of the Tensile Deformation Modes and Anisotropy of Extruded Mg-10gd-3y-0.5zr (wt.%) at Elevated Temperatures

Influences of Tensile Temperature on the Mechanical Properties of Rolled Mg-Zn-Gd Sheets with Non-Basal Texture

Flow Behavior and Microstructural Evolution of ZW61 Alloy During Hot Compressive Deformation

Deformation Behavior of ZK60 Magnesium Alloy at Elevated Temperature

Effect of pre-induced precipitations on microstructure evolution and the mechanical properties of pre-twinned ZK61 Mg alloys at elevated temperatures

Microstructure evolution, strengthening mechanisms and deformation behavior of high-ductility Mg−3Zn−1Y−1Mn alloy at different extrusion temperatures

Room-Temperature Strengthening, Portevin-Le Chatelier Effect, High-Temperature Tensile Deformation Behavior, and Constitutive Modeling in a Lightweight Mg-Gd-Al-Zn Alloy

Study on Thermal Compression Deformation Behavior and Constitutive Model of Homogenized Mg–5Zn–1Mn Alloy

Hot Deformation Behavior and Microstructure Evolution of a Novel High-Zn Containing Al-Zn-Mg-Cu-Zr Alloy

Dynamic Microstructural Changes During Hot Extrusion and Mechanical Properties of a Mg–5.0 Zn–0.9 Y–0.16 Zr (wt.%) Alloy

Investigation of microstructure and tensile properties of as-processed TZM alloy at elevated temperature

Microstructure Evolution and Deformation Behavior of Extruded Mg-5Al-0.6Sc Alloy during Room and Elevated Temperature Tension Revealed by Ex-Situ EBSD and VPSC

Study on Tensile Behavior at Various Temperatures of the Mg-7Gd-5Y-1Nd-2Zn-0.5Zr Alloy

Dynamic recrystallization and twinning behavior of magnesium alloy during hot tension