Abstract:The ultimate limit state (ULS) is one of the design criteria used in the oil and gas industry in mooring system design for floating platforms. The 100 year level response in the mooring line should be applied for the ULS design check, which is ideally estimated by taking into account the dynamic mooring line tension in all sea states available at the operational site. This approach is known as a full long-term response analysis using the all-sea-state approach. However, this approach is time consuming, and therefore, the contour line method is proposed for estimation of the 100 year response by primarily studying the short-term response for the most unfavorable sea states along the 100 year environmental contour line. Experience in the oil and gas industry confirmed that this method could yield good predictions if the responses at higher percentiles than the median are used. In this paper, the mooring system of a two-body wave energy converter (WEC) is considered. Because this system involves the interaction between two bodies, the estimation of the ULS level response using the all-sea-state approach may be even more time consuming. Therefore, application of the contour line method for this case will certainly be beneficial. However, its feasibility for application to a WEC case must be documented first. In the present paper, the ULS level response in the mooring tension predicted by the contour line method is compared to that estimated by taking into account all sea states. This prediction is achieved by performing coupled time domain mooring analyses using Simo/Riflex for six cases with different mooring configurations and connections between two bodies. An axisymmetric Wavebob-type WEC is chosen for investigation, and the Yeu site in France is assumed as the operational site. Hydrodynamic loads including second-order forces are determined using Wamit. Finally, the applicability of the contour line method for prediction of the ULS level mooring tension for a two-body WEC is assessed and shown to yield accurate results with the proper choice of percentile level for the extreme response.

Sensivity Analysis of Tensioned–Leg Mooring Line Under Variations of Water Depth

Quasi-Static Analysis of the Multicomponent Mooring Line for Deeply Embedded Anchors

Quasi-Static Analysis Of The Multi-Component Mooring Line For Suction Anchors

Investigations on the Mooring Safety Considering the Coupling Effect of the Mooring Line Snap Tension and Anchor Out-of-plane Loading

Experimental Investigation on Responses Characteristics of a Mooring Line with Imposed Top-End Motions

Quasi-static Analysis Model of Suction Caisson Mooring Line

A Hydrodynamical Study on Motions and Mooring Loads of the Small Scale LNG Carrier

Quasi-static Three-Dimensional Analysis of Suction Anchor Mooring System

A review on mooring lines and anchors of floating marine structures

Seabed Trenching Near the Mooring Anchor: History Cases and Numerical Studies

Localization and topological observability analysis of a moored floating structure using mooring line tension measurements

Dynamic Analysis of a Symmetrically Moored Semisubmersible Under Various Possible Mooring Combinations

Effect of Mooring Parameters on Dynamic Responses of a Semi-Submersible Floating Offshore Wind Turbine

Development of a numerical mooring line model for a floating wind turbine based on the vector form intrinsic finite element method

Numerical Assessment on the Dynamic Behaviour of Submarine Hoses Attached to CALM Buoy Configured as Lazy-S under Water Waves

A Mooring System Deployment Design Methodology for Vessels at Varying Water Depths

Dynamic Response Analysis of the Equivalent Water Depth Truncated Point of the Catenary Mooring Line

Application of the Contour Line Method for Estimating Extreme Responses in the Mooring Lines of a Two-Body Floating Wave Energy Converter

Numerical Investigations on Load Transfer of Mooring Line Considering Chain–seabed Dynamic Interaction

Sensitivity Studies on Offshore Submarine Hoses on CALM Buoy with Comparisons for Chinese‑Lantern and Lazy‑S Configuration:OMAE2019‑96755

A fully coupled dynamic water-mooring line system: Numerical implementation and applications