Fault Tolerant Sensorless Control Strategy With Multi-States Switching Method for In-Wheel Electric Vehicle

Zihui Wang,Jincai Shao,Zhiyuan He
DOI: https://doi.org/10.1109/access.2021.3072700
IF: 3.9
2021-01-01
IEEE Access
Abstract:The in-wheel electric vehicle with distributed drive units has better stability and flexibility than traditional centralized drives, but may encounter a higher failure rate due to additional actuators and sensors, especially that the faults of the wheel-side position sensor make motor torque out of control. To overcome this problem, a fault-tolerant control strategy with a multi-states switching method is proposed. The strategy judges the sensor failure by verifying redundant speed information, realizes sensorless control schemes by flux-observer based algorithm in high-speed range and I-F control algorithm in low-speed range with low acoustic noise, and applies adaptive transition process between different control schemes. To pursuit high stability, the signal-to-noise analysis for fault judgment due to sensorless estimation accuracy is discussed. Meanwhile, the principle of I-F resonant oscillations during the transition process is initially deduced in detail, and the conclusion of stability condition is obtained. Finally, the influence of system parameters on resonance performance is analyzed by simulation, and the effectiveness and reliability of the proposed strategy for the risk-controlling process are verified by experiments.
computer science, information systems,telecommunications,engineering, electrical & electronic
What problem does this paper attempt to address?
The paper aims to address the issue of high failure rates in distributed drive units of in-wheel electric vehicles due to the addition of extra actuators and sensors. Specifically, it focuses on the potential motor torque runaway situation that can occur when a wheel-side position sensor fails. To solve this problem, the paper proposes a fault-tolerant control strategy based on a multi-state switching method. This strategy determines sensor faults by verifying redundant speed information and employs a flux observer-based algorithm in high-speed ranges and an I-F control algorithm in low-speed ranges to achieve a sensorless control scheme, thereby reducing noise. Additionally, the strategy applies an adaptive transition process between different control schemes to pursue higher stability. Specifically, the paper derives in detail the impact of signal noise analysis during the I-F resonance oscillation process and the accuracy of sensor fault determination, and concludes the stability conditions. Finally, it analyzes the impact of system parameters on resonance performance through simulation and verifies the effectiveness and reliability of the proposed strategy in the risk control process through experiments. In summary, the paper aims to improve the stability and safety of in-wheel electric vehicles in the event of sensor failures.