Abstract:Battery electrolytes play an important role in battery performance and safety. To improve the formation of a solid-electrolyte interface (SEI) and overall performance, additives such as vinylene carbonate (VC) and fluoroethylene carbonate (FEC) are added to the electrolyte. A thorough understanding of the aging process is critical to the safe operation of batteries. The reactions of the liquid electrolyte, its additives and the associated gas formation play a decisive role in cell aging and cell safety. Thus they are in the focus of the BatgasMod project (Modelling of battery gassing) funded by the German Federal Ministry of Education and Research (BMBF) in the framework of the competence cluster Battery usage concepts (BattUse). The aim of the BatgasMod project is the modeling of the gassing behavior of batteries over their lifespan and the combination of electrolyte aging models with battery models for an early prediction of cell behavior in the usage phase. In order to support the modeling with aging data, three different cell variants were produced, differing in terms of their electrolyte composition. The cells were assembled at the MEET by combining commercial LiNi 0.6 Mn 0.2 Co 0.2 O 2 (NMC622) cathode and graphite anode material together with a ceramic coated separator. The electrolyte for all three cell types is a mixture of the organic solvents EC and EMC in a ratio of 3:7 with 1M LiPF 6 . This composition without additives represents the reference cell. To investigate the influence of the additives, cells were prepared with either 5 wt.-% vinylene carbonate (VC) or 5 wt.-% fluoroethylene carbonate (FEC) as an additive. First, both at IAM-AWP and ISEA cell formation was performed to study the entire life of the cells, including the critical step of SEI formation in the first cycles. After degassing, the cells were subjected to 10 additional cycles to obtain a stable capacity for the start of the aging tests. The cells were stored in temperature chambers at 25°C with SOCs of 100%, 80%, 30% and 5%. At IAM-AWP measurements were performed under open circuit conditions to allow for self-discharge. For comparison, at ISEA the cells were aged under floating SOC conditions, i.e. the SOCs were kept constant throughout the entire measurement. At predetermined time intervals, the cells were checked for remaining capacity and pulse resistance. In both measurements the influence of the SOC is clearly visible and the high SOC leads to an increased aging. The electrolyte additives showed different results for the different aging tests. The cells without additives outperform the cells with additives under open circuit conditions. This unusual behavior was further investigated and was attributed to the high self-discharge of the cells without additives. As a result, the voltage drop leads to a lower storage SOC, which was beneficial for the aging of these cells. The electrolyte additives showed deviating results for the different aging tests. The floating SOC measurements revealed a superior performance of the cells with additives. In addition, it was found that cells containing VC have lower capacity loss but higher resistance increase than cells containing FEC. Differential voltage analysis and incremental capacity analysis were performed to better understand the dominant aging mechanisms. These methods suggest that a combination of loss of lithium inventory and impedance rise causes cell degradation. These results provide guidance for improving calendar aging by selecting the most appropriate electrolyte additive. Future work will focus on comparing the influence of additives on the safety of fresh and calendar aged cells.

Aging Mechanism For Calendar Aging of Li-Ion Cells With Si/Graphite Anodes

Unraveling the Complex Temperature-Dependent Performance and Degradation of Li-Ion Batteries with Silicon-Graphite Composite Anodes

Pouch cells with 15% silicon calendar-aged for 4 years

An Analysis of Calendaric Aging over 5 Years of Ni‐rich 18650‐Cells with Si/C Anodes

Critical Contribution of Imbalanced Charge Loss to Performance Deterioration of Si-Based Lithium-Ion Cells during Calendar Aging

Exacerbated High‐Temperature Calendar Aging of SiOx‐Graphite Electrode Induced by Interparticle Lithium Crosstalk

Calendar Aging and Gas Generation in Commercial Graphite/NMC-LMO Lithium-Ion Pouch Cell

A mechanistic calendar aging model of lithium‐ion battery considering solid electrolyte interface growth

Calendar Aging of Lithium-Ion Batteries: Investigating the Influence of Electrolyte Additives in Open-Circuit and Floating State-of-Charge Conditions

Scanning Electrochemical Microscopy Reveals That Model Silicon Anodes Demonstrate Global Solid Electrolyte Interphase Passivation Degradation during Calendar Aging

Degradation of sodium co-intercalation chemistry and ether-derived interphase on graphite anodes during calendar aging

Analysis and Modeling of Calendar Aging and Cycle Aging of LiCoO2/Graphite Cells

Degradation Mechanisms of High Capacity 18650 Cells Containing Si-graphite Anode and Nickel-Rich NMC Cathode

Extending the Calendar Life of LiNi0.8Co0.1Mn0.1O2-based 0.8 Co 0.1 Mn 0.1 O 2-Based Lithium-Ion Batteries Via Low-Temperature Storage

Extending the Calendar Life of LiNi0.8Co0.1Mn0.1O2-based Lithium-Ion Batteries Via Low-Temperature Storage

Depletion of Electrolyte Salt Upon Calendaric Aging of Lithium-Ion Batteries and its Effect on Cell Performance

Nano-FTIR Spectroscopy of the Solid Electrolyte Interphase Layer on a Thin-Film Silicon Li-Ion Anode

Aging mechanisms of NMC811/Si-Graphite Li-ion batteries

(Invited) Calendar Life Analysis of Si-Containing Anodes for Li-Ion Batteries

Assessing Electrolyte Fluorination Impact on Calendar Aging of Blended Silicon-Graphite Lithium-Ion Cells Using Potentiostatic Holds

Electrochemical Modeling of Calendar Capacity Loss of Nickel-Manganese-Cobalt (NMC)-Graphite Lithium Ion Batteries