Abstract:The sensitivity of gravitational-waves detectors is characterized by their noise curves which determine the detector's reach and the ability to accurately measure the parameters of astrophysical sources. The detector noise is typically modelled as stationary and Gaussian for many practical purposes. However, physical changes in the state of detectors due to environmental and instrumental factors, including extreme cases where a detector discontinues observing for some time, introduce non-stationarity into the noise. Even slow evolution of the detector sensitivity will affect long duration signals such as binary neutron star (BNS) mergers. Mis-estimation of the noise behavior directly impacts the posterior width of the signal parameters. This becomes an issue for studies which depend on accurate localization volumes such as i) probing cosmological parameters (such as Hubble constant, clustering bias) using cross-correlation methods with galaxies, ii) doing electromagnetic follow-up using localization information from parameter estimation done from pre-merger data. We study the effects of dynamical noise on the parameter estimation of the GW events. We develop a new method to correct dynamical noise by estimating a locally-valid pseudo PSD which is normalized along the time-frequency track of a potential signal. We do simulations by injecting the BNS signal in various scenarios where the detector goes through a period of non-stationarity with reference noise curve of third generation detectors (Cosmic explorer, Einstein telescope). As an example, for a source where mis-modelling of the noise biases the signal-to-noise estimate by even $10\%$, one would expect the estimated localization volume to be either under or over reported by $\sim 30\%$; errors like this, especially in low-latency, could potentially cause follow-up campaigns to miss the true source location.

On line power spectra identification and whitening for the noise in interferometric gravitational wave detectors

Noise parametric identification and whitening for LIGO 40-meter interferometer data

Rapid acceleration of electrons in the magnetosphere by fast-mode MHD waves

Machine learning for gravitational-wave detection: surrogate Wiener filtering for the prediction and optimized cancellation of Newtonian noise at Virgo

Adaptive algorithms for low-latency cancellation of seismic Newtonian-noise at the Virgo gravitational-wave detector

Design and implementation of a seismic Newtonian-noise cancellation system for the Virgo gravitational-wave detector

Gravitational-Wave Burst Signals Denoising Based on the Adaptive Modification of the Intersection of Confidence Intervals Rule

Design and implementation of a seismic Newtonian noise cancellation system for the Virgo gravitational-wave detector

A Sensitive Test of Non-Gaussianity in Gravitational-wave Detector Data

Detector Characterization and Mitigation of Noise in Ground-Based Gravitational-Wave Interferometers

The VIRGO Project: A wide band antenna for gravitational wave detection

Bayesian power spectral estimation of gravitational wave detector noise revisited

DeepClean: Non-Linear Regression for Noise Reduction in the Virgo Detector

On the (In)Efficiency of the Cross-Correlation Statistic for Gravitational Wave Stochastic Background Signals with Non-Gaussian Noise and Heterogeneous Detector Sensitivities

Wavescan: multiresolution regression of gravitational-wave data

Characterization of the seismic field at Virgo and improved estimates of Newtonian-noise suppression by recesses

Gravitational-Wave Stochastic Background Detection with Resonant-Mass Detectors

Parameter estimation with non stationary noise in gravitational waves data

Beyond the Long Wavelength Approximation: Next-generation Gravitational-Wave Detectors and Frequency-dependent Antenna Patterns

chi sup 2_ testing of optimal filters for gravitational wave signals: An experimental implementation