Comment on "Theory of diluted magnetic semiconductor ferromagnetism"

Min-Fong Yang,Shih-Jye Sun,Ming-Che Chang

DOI: https://doi.org/10.1103/PhysRevLett.86.5636

2000-08-07

Abstract:In this comment, we emphasize that the self-consistent spin wave theory in a recent paper [J. K"onig, H.-H. Lin, and A. H. MacDonald, Phys. Rev. Lett. 84, 5628 (2000)] leads to incorrect results both at low temperatures and near T_c. Thus we suggest another self-consistent spin wave approximation to remedy these flaws.

Mesoscale and Nanoscale Physics

What problem does this paper attempt to address?

The problems that this paper attempts to solve are several key technical challenges faced by the radio - frequency (RF) system of the linac in the Next Linear Collider (NLC). Specifically, these problems include:

1. **Broad - band klystron modulation and accurate RF vector detection**:
- The NLC requires a large number of new linac RF systems, which must be able to support broad - band klystron modulation and have the ability of accurate RF vector detection. To achieve this, the system needs to be able to perform phase adjustment automatically for each klystron and compensate for the phase change caused by the beam - loading effect.

2. **Alignment of the accelerating structure**:
- To ensure the transverse alignment accuracy of the accelerator structure, the alignment situation must be determined by detecting the dipole mode induced by the beam. This requires a receiver similar to that used for measuring the accelerator RF and integrating it into the topology of the RF system.

3. **Pulse stacking and beam - loading compensation**:
- The pulse - stacking technique is used to efficiently generate the required 600MW, 300ns RF pulse. To achieve rapid beam - loading compensation, the klystron drive signal needs to be rapidly modulated. In addition, a programmable digital intermediate frequency (IF) solution is required to achieve this goal.

4. **Absolute phase control**:
- The absolute phase of the accelerating RF relative to the beam is a key parameter and must be measured and controlled at the X - band level (within 1 degree). Even with the most advanced fiber - optic RF reference / distribution system, there may still be phase drift in the system, so the relative phase between the beam and the accelerating RF needs to be measured regularly.

5. **High - dynamic - range measurement**:
- Measuring the RF / beam phase during single - beam operation is one of the most challenging tasks. For example, the RF signal generated by a single pilot beam containing 1e9 particles is 40dB lower than the accelerating RF. Therefore, dithering techniques need to be applied and multiple pulses need to be averaged to improve the measurement accuracy.

By proposing and testing the digital intermediate frequency (IF) technology, this paper aims to solve the above problems to achieve efficient, accurate and automated operation of the RF system in the NLC.